Product Details

20m Heavy duty telescopic high mast 260Kg payload pole pneumatic telescoping tower mast

Product Photo

Product Description

20m Heavy duty telescopic high mast 260Kg payload pole pneumatic telescoping tower mast

1.Basic specifications

Product name	20m Heavy duty telescopic high mast 260Kg payload pole pneumatic telescoping tower mast
Material	6063 aluminum alloy
Closed length	3.30m (Bottom base included)
Extended length	20.0m (Bottom base included)
Max.payload	260kgs
Lifting method	pneumatic lifting
Color	light brown
Surface treatment	Phosphoric acid anodizing
Section	9
Wind load max.	100 km/h
Max Working pressure of air compressor	0.25MPA
Working temperature	-15--+60℃
Inside cable	1pc CAT5 for camera+2pcs AWG14 for light+2pcs RG59 for VHF antenna
Lifting time	about 3 mins
Air compressor	Power:DC12V 45A pressure:30PSI output volume : about 160L/min
Diameter of plate	229/202/180/160/140/118/98/82/66 mm

2.Accessories

No	Items	Qty	Total
1	20m Main pole	1 set	1 set
2	5m Pu air tube	1 piece	1piece
4	12V air compressor	1 piece	1 piece
5	Top plate	1 unit	1 unit
7	cable	1pc CAT5+2pcs AWG14 +2pcs RG59	5pcs

3.Accessories available photos

Packaging & Shipping

One unit of Heavy duty telescopic high mast to be wrapped with Poly tapes then two or one sets packed into a carton, carton inner covered by hard foam

Workshop

Installation

A. Fixed mode: achieved by tripod; vehicle mode: fixed by car clamps

B. The telescopic mast should be mounted on a flat and solid foundation. If the mast is tilted or tilted for a long time, its speed will be affected and it will cause damage to the mast itself.

C. The top load of mast should not exceed its conventional bearing so as not to tilt or damage the mast

D. Telescopic mast above 10m or less than 10m (including 10m) carrying more than 5kg must be fitted with pulling cords.

E. And the mast need be fitted with pulling cords when the wind speed exceeds 14m/s.

F. Method for erecting a mast with pulling cord (take a three layer pulling cord mounted on the ground as an example):

a. The telescopic mast should be vertically fixed on the horizontal base.

b. The position selection of ground anchors. The distance between ground anchor and the bottom center of mast is greater than 2/3 of the height of the mast, and nails shall be driven into ground every 120 degrees.

Contact

		Ms. Karen Wang
		Talents Enterprise Company Limited
		T: 86 22 28376666 \| F: 86 22 28376667 \|
		whatsapp:0086 182 0221 3131
		W: