Product Details

10m pneumatic portable lightweight telecommunication mast with tripod

Product Photo

Product Description

10m pneumatic portable lightweight telecommunication mast with tripod

1.Basic specifications

Product name	10m pneumatic portable lightweight telecommunication mast with tripod
Material	6063 aluminum alloy
Closed length	2.6m (Bottom base included)
Extended length	10.00m (Bottom base included)
Max.payload	10kgs
Lifting method	pneumatic lifting
Color	light brown
Surface treatment	Phosphoric acid anodizing
Section	5
Wind load	80 km/h
Max Working pressure of air compressor	0.25MPA
Working temperature	-15--+60℃
Lifting time	about 3 mins
Air compressor	Power:DC12V 45A pressure:30PSI output volume : about 160L/min
Diameter of top plate	150mm, there are four hole diameter 11mm

2.Accessories

No	Items	Qty	Total
1	10m Main pole	1 set	1 set
2	5m Pu air tube	1 piece	1piece
3	Car clamp	1 piece	1piece
4	12V air compressor	1 piece	1 piece
5	Top plate	1 unit	1 unit
6	Guy wire	6 pieces	6 pieces

Packaging & Shipping

One unit of pneumatic lightweight mast to be wrapped with Poly tapes then two or one sets packed into a carton, carton inner covered by hard foam

Workshop

10m pneumatic portable lightweight telecommunication mast with tripod

Installation

A. Fixed mode: achieved by tripod; vehicle mode: fixed by car clamps

B. The telescopic mast should be mounted on a flat and solid foundation. If the mast is tilted or tilted for a long time, its speed will be affected and it will cause damage to the mast itself.

C. The top load of mast should not exceed its conventional bearing so as not to tilt or damage the mast

D. Telescopic mast above 10m or less than 10m (including 10m) carrying more than 5kg must be fitted with pulling cords.

E. And the mast need be fitted with pulling cords when the wind speed exceeds 14m/s.

F. Method for erecting a mast with pulling cord (take a three layer pulling cord mounted on the ground as an example):

a. The telescopic mast should be vertically fixed on the horizontal base.

b. The position selection of ground anchors. The distance between ground anchor and the bottom center of mast is greater than 2/3 of the height of the mast, and nails shall be driven into ground every 120 degrees.

Contact

		Ms. Cindy Wang
		Talents Enterprise Company Limited
		T: 86 22 28376666 \| F: 86 22 28376667 \|
		whatsapp:0086 156 2061 6406
		W: