22m electric CCTV lighting mast tower telescoping tv antenna mast electric telescopic lifting rod

  (1) Main pole in 9 sections:

Section No.     OD         Thickness     Length

1#                   30mm         2.0mm         2.3mm

2#                   40mm         2.0mm         2.3mm

3#                   50mm         2.0mm         2.3mm

4#                   60mm         2.0mm         2.3mm

5#                   70mm         2.0mm         2.3mm

6#                   80mm         2.0mm         2.3mm

7#                   90mm         2.0mm         2.3mm

8#                  105mm        2.5mm         2.3mm  

9#                  130mm        4.0mm         2.3mm

(2) Other parts of the mast body

Top plate Thickness: 8 mm     Diameter:180 mm  Screw:4pcs of dia.10mm

  Bottom base(include motor): size:220*550mm   

(3)Accessories

Motor: (AC220V 550W)-------------------------------     1  set

Pulling cord box with handle bars-------------------3  units  

Ground anchor------------------------------------------- 3  pieces

Handle lifting bar---------------------------------------- 1  piece

Remote-controller --------------------------------------2  pieces

Tripod-------------------------------------------------------1  unit

Material:

Main Pole: Section 1-7 aluminum 2A12T4, section 8-9 aluminum 6063

Bottom base and accessories (except the ground anchor): iron steel

Ground anchor:galv stainless steel   

Pulling cord: stainless steel wire(OD:2mm)

Color: the whole unit will be in silver when closed, but when extended, the main pole will be in origin color of aluminum alloy only with top 4cm of each pole section in silver color

Color Technology: painting

Accessories

1.Pulling cord

2. Ground anchor

3.Control box

4.Handle lifting bar for lifting the mast

5. Handle bar for Pulling cord box

Installation

 A. Fixed mode: achieved by tripod; vehicle mode: fixed by car clamps

B. The telescopic mast should be mounted on a flat and solid foundation. If the mast is tilted or tilted for a long time, its speed will be affected and it will cause damage to the mast itself.

C. The top load of mast should not exceed its conventional bearing so as not to tilt or damage the mast

D. Telescopic mast above 10m or less than 10m (including 10m) carrying more than 5kg must be fitted with pulling cords.

 E. And the mast need be fitted with pulling cords when the wind speed exceeds 14m/s.

 F. Method for erecting a mast with pulling cord (take a three layer pulling cord mounted on the ground as an example):

    a. The telescopic mast should be vertically fixed on the horizontal base.

    b. The position selection of ground anchors. The distance between ground anchor and the bottom center of mast is greater than 2/3 of the height of the mast, and nails shall be driven into ground every 120 degrees.

Contact 

		Ms. Karen Wang
		Talents Enterprise Company Limited
		T: 86 22 28376666 | F: 86 22 28376667 |
		whatsapp:0086 182 0221 3131
		W: