25m hand lifting telescoping antenna mast  with tripod

  (1)Main pole in 10 sections:

Section No.     OD         Thickness     

 1#                30mm       2.0mm           

 2#               40mm        2.0mm           

 3#               50mm        2.0mm           

 4#               60mm        2.0mm          

 5#               70mm        2.0mm           

 6#               80mm        2.0mm           

 7#               90mm        2.0mm           

 8#              105mm       2.5mm           

 9#              130mm       4.0mm

10#             150mm       3.0mm         

(2)Top plate Thickness: 10mm     Diameter:130mm   hole size:4pcs of dia.10mm

      Bottom base:180*180mm

(3)Accessories:

Pulling cord box with handle bars------------------3  units  

Ground anchor----------------------------------------3  pieces

Handle lifting bar-------------------------------------1  piece

Tripod --------------------------------------------------1  piece

(4)Material:

Main Pole: aluminum alloy            

Bottom base and accessories (except the ground anchor): iron steel

Ground anchor: galv stainless steel   

Guy wire:nylon

(5)Color: the whole unit will be in army green when closed, but when extended, the main pole will be in origin color of aluminum alloy only with top 4cm of each pole section in army green color.  

(6)Color Technology: painting

Accessories

1.Pulling cord box and handle bars

2. Ground anchor                                                                                3.Handle lifting bar  

25m tripod manual high telescopic mast 

Installation

A.Manual telescopic mast on the ground

1.Determine the mounting position of telescopic mast and ground anchor, hitting one nail per 120 degrees.

2.Ground anchor is nailed to the direction of the mast.

3.The base is fixed with the ground nail, and the direction of the three pulling holes is aligned with the direction of the three ground anchors, and the three hanging boxes are respectively hung on the three pull rings.

4.The handle bar of the mast is inserted into the bottom of motorized telescopic mast, and the hand crank is rotated clockwise, and the mast body is vertical to the ground until the required height is reached.

B.Vehicle mounted manual telescopic mast

1.Determine the installation position, the bottom plate and the vehicle axis should be parallel, and the area should be equivalent to the size of the body floor area, so that the handle bar has a revolving space.

2. The mast is perpendicular to the horizontal plane of the vehicle in the installation of the bottom plate and car clamp of the mast.

3.During the whole installation, the position of bottom plate and car clamp must be ensured at the same time.

4.Car clamp and bottom bracket should be installed on the object which can not be displaced.

5.The clamps can not be installed too tight, so as to avoid the deformation and normal work of the mast.

Contact 

		Ms. Karen Wang
		Talents Enterprise Company Limited
		T: 86 22 28376666 | F: 86 22 28376667 |
		whatsapp:0086 182 0221 3131
		W: