1. 4-way air flow, which can even temperature distribution in the room

2. Specially design to avoid the air-short flowing

3. Thin design unit which can be installed in a limit ceiling (min. thickness 290 mm)

4. Easy to be installed, low installation cost

5. Remote controller is standard and wire controller is optional

6. Auto swing

    Using advanced 3D software to design the centrifugal fan with streamline and big diameter turbine.

7. Quiet running

8. High lift water drained pump (750 mm), easy to locate the condensate drained pipe

9. Float switch inside to prevent from leaking

10. K style cassette fan coil unit can maintain the pump and water level switch from the external of the unit, can be easily examine and repair the pump as long as just remove 4 screws

11. External drained part is optional, convenient for      12. "C" type heat exchanger which is helpful to 

maintenace                                                                            improve the well-distributed of terminal air duct 

                                                                                                 and refrigerant system, make the efficiency of                                                                                                          multi-flow more even and it reduced the probable                                                                                                    of system leakage.

13. Fresh air can be drawn from outside

      Fresh air inlet can import some fresh wind from outside and ensure the quality of indoor air. Thus, the consumer can share the fresh and clean air to lessen illness caused by air condition.

14. Auxiliary duct is available to send part of air to other place, in order to improve indoor temperature air quality

15. The water remain in the tray is easy to drained manually.

16. Square panels, which can allow users to choose the direction of inlet/outlet water connection freely

17. Fan and fan motor is easy to maintain

      After take out the air grid of the panel, users can easily take out the electric box, then the fan and fan motor can be easily taken out too.

18. The dimension of K1 unit is only 570*570 mm,        19. 4-tube system is optional for both cooling and 

which can be installed in a standard ceiling opening      heating water circle coil inside so that it can work

                                                                                                   for cooling and heating at the same time.

20. Easily interfaced with most widely used BMS and proprietary supervisory system based on Mod-Bus protocol.

20. Water valve can be installed outside the unit (optional).

      Water valve is used to control the on/off water flow to the unit, users can install the valve outside the unit, so the user do not need to installed it by themselves.