Operation regulation of hydraulic baler

connect 380V degree power supply, add 46# hydraulic oil (single cylinder 50kg double cylinder 75kg).

 After assembling, check whether all bolts are loose. After tightening up, check the oil quantity before you can try the machine.

 This product is used for waste paper packaging. Operators must operate according to the operation rules.

 the hydraulic oil must be added to the required oil level line before use, (46# hydraulic oil).

Before starting the hydraulic pump, check if there is any wrong connection or leakage.  

 the reverse side of the hydraulic board should be cleaned every time, so as to avoid sticking.  

When packing, the operator must pay attention to safety, lay paper evenly, lay paper in place, should be the top of the box cover door closed, can start packing.

 When packing, the hydraulic handle should be pushed to the designated position quickly, in case the hydraulic handle is pushed to the designated position quickly and the flow of hydraulic oil is insufficient when the valve is packed, resulting in motor overcurrent.

All hydraulic rods must be retracted into the cylinder after packing, in order to prevent dust damage to the sealing ring and oil leakage.

 regular maintenance work, found that there is oil leakage in the oil pipe immediately find mechanic division.

If an abnormal condition is detected, the operation should be stopped immediately.   

After opening the box door, no door operation is strictly prohibited to prevent accidents.  

 oil pressure: no unauthorized voltage regulation is strictly prohibited. Operators must work well under the condition of adjusting oil pressure.The maximum voltage limit is 15MPa.  

the oil in the tank must be filtered strictly and always keep enough oil. The tank should be cleaned and replaced once a half year.  

 Every lubricating place of the machine should be filled with lubricating oil at least once a day as required. Every shift should clean up the impurities in the secondary chamber.  

do not understand the main machine structure, performance and operation procedures are not allowed to start the machine. When many people operate at the same time, the division of labor should be clear so as to avoid the risk of misoperation.  

When serious oil leakage or abnormal phenomena occur in the work of the machine, stop your eyes immediately and do not look at the place where the oil is sprayed. You can not plug it directly with your hands. You can not force it to run with disease.

 When the machine is in operation or packing, it is forbidden to repair or touch the moving parts by hand. It is forbidden to press materials in the bin with hands or feet.  

 Pump, valve and pressure gauge must be adjusted by experienced technicians. If the pressure gauge is found to be faulty, it should be repaired or replaced immediately.  

 the machine uses 46# to resist wear oil, often pay attention to oil temperature, when more than 75 degrees centigrade should stop.  

When the lid cylinder handle is turned back to the position when the bag is turned over, the pressure cylinder is compressed into the cylinder and then the reverse handle is pushed.