1).Brief introduction
RDJ-B HOT MELT MACHINE is designed for the hot melt of insulating glass with aluminum spacer. It is of the second generation of equipment with the same model. It is small and light, easy to operate and repair and has stable control over temperature. Operation can be carried out after preheating of half an hour. (there is sealant table can help to make it)
2).Installation and Trial Run
No special conditions are required except that the operation site is kept clean.
Make sure the power be connected correctly in accordance with the requirements.
Put the designated rubber block in the rubber box, set the temperature (reference degree being 150°C-170°C) and preheat it for about 30 minutes.
When the set temperatures of the rubber and rubber pipe have been satisfied, triggering the rubber gun can extrude the hot melt.

2.Technical parameters