LH-CO1 Portable residual chlorine detector measure test analysis

Introduction

The instrument can provide the same measurement results as the national standard method for the use of the personnel, and the simple operation interface without professional on-site operation can get accurate results through the color meter.

Using the instrument only on the boot, zero, reading, you can quickly complete the analysis and testing of the sample, small size, easy to carry, quality comparable to imported similar products.

Widely used in urban water supply, food and beverage, environment, medical, chemical, pharmaceutical, thermoelectric, paper, aquaculture, bio engineering, fermentation process, textile printing, petrochemical, water treatment and other fields of rapid detection of water quality.

 Features

Simple operation interface, no need for professional personnel on-site operation can get accurate results through the color meter.

Quick analysis speed - up - to - zero - > reading, three minutes to complete a sample test.

Accurate measurement results - the measurement results are consistent with the national standard method at anytime and anywhere.

Economic test cost - quality comparable to imported similar products, but the cost is only about 1/3 of imported products.

Lightweight design - small size, light weight, easy to carry.

 Technical parameter

Determination range: 0 ~ 3.00mg/L

Light source: silicon light diode

Wavelength: 510nm

Accuracy: ±0.05mg/L (measured value < 1 mg/L)

±0.10mg/L (measured value > 1 mg/L)

Methods: using the standard DPD method, the amount of residual chlorine or chlorine and DPD reagent, the sample solution was red.

Environment: temperature 0 ~ 40℃, relative humidity 0~90% (no condensation)

Batterylife: 1 x 9V, 40 hours or more.

Power off: after the color meter, press "ON/OFF" to shut down.

Dimensions: 170 x 70 x 30mm

Weight: 200g (including battery)