Hot selling  Mini Manual sealing machine

1.Technical data of sealing machine

Type: WTET-D8    

Power Supply: 220V/50Hz 

Power:300W

 Out Put:300-400cup/h 

weight:15kg

Size:205*265*460mm

2. Film material and the sealing temperature

 1,PE:170℃

 2,PP:170℃~200℃

 3,PS:180℃

 4, Peeling Tape:120℃~180℃

 5,PET:160℃~200℃

3.Method of use
(a) through film
1, to get the film need to confirm the film winding direction, find out counterclockwise, and instead of a cast, a splint round clamp on the film fixed on the shaft.Please shut off the power (in film)
2, pay attention to whether the film fixed splint and film together, if can't together, by will film paper tube inside cutting knife bevel again into.

 3, wear good film with adhesive film firmly on the receiving tube.

(b) the sealing step instructions (panel)
1, connected to the power supply, open the power switch, indicator, set the thermostat to the predetermined temperature, heating the green indicator lights.After the hot plate to the expected temperature, constant temperature indicator red (sealing machine at work, in a state of heating and heat preservation alternating electric heating device, green and red indicator light is alternating, according to which belongs to the normal phenomenon).
2, put the cup into the lower die plate, with the hand will lower die slide push to determine its location and position, press the handle of dynamic sealing machine to the maximum, the holding 1 ~ 2 seconds, then slowly rising handle, and pushed to its original position.
3, pull out the slip board, take out the plastic cup, into the sealing rubber cup, another cycle.

4.Pictures of sealing machine