vertical hydraulic baling machine for straw and plastic

 g baler machine

Introduction:

The machine mainly applicates to the packing of maize straw, rice wheat grass, hay production, waste plastics, waste paper, waste sponge, waste rubber, beverage cans,cotton, rag etc.

It improves the work efficiency, reduce labor intensity,reduce shipping cost and save place;environmental protection,safety, it is the good equipment of regeneration company to increase capacity.Moreover,it adopts hydraulic drive.

Our Automatic baling machine can compress loose waste matter into tightly managable bales.  These bales will not only save space in shipping but also save on loading time.

Working principle

1.Hydraulic baling press including support, and the support with plate and the former back side baffle, the support is installed on jack, jack with piston rod, piston rod right end connected to a vertical of pushing board, pushing plate on the right side is connected with pushing batten, adjacent pushing the gap between batten for board wear rope groove.

2.Bracket above right section with pressure material on board, pressure material on the left side of the damper bracket above with feed mouth; Former rear side baffle on the right side of the stents were fixed connection on a side before article block, adjacent side in the space between the article for lacing mouth; Support the right end with a dry mouth, dry mouth place support right end hinged have door, door plank left lateral connection door panel, door plank of the gap between the adjacent article for door wearing rope groove.

3. Former rear side baffle pushing board and floor surrounded the cavity for feed cavity, the former back side article block material pressure on baffle plate and bottom surrounded.

Main Parameter

Model: TZ-110

Power:7.5kw

Capacity: 6-8bags/h

Max work pressure :10T

Size of machine :1450mm×700mm×2830mm

Model: TZ-330

Power: 11KW

Capacity: 6-8bags/h

Max work pressure :10T

Size of machine : 1800mm×750mm×3350mm