Prepare before starting up:

1. First fix the meat and vegetable bowel machine device smoothly, pay attention to the four corners and the ground, and then connect the power supply.
2. Before the test run, check whether the boring machine knife and other parts are loose during transportation. If the confirmation is correct, you can test the vehicle.
3. Jog the discharge switch or the pot switch before the test (the counter is counterclockwise). If the discharger or the crucible rotates in the opposite direction, you need to change the power line before you can test the vehicle. (The 40 type chopping machine has no discharge device. It is necessary to jog the pan or low speed to observe the rotation direction of the file to judge whether the wiring is correct.)

Rational use of the machine

1. The sharpness and high speed of the meat and vegetable bowel machine are all you need to pay attention to during the use. hope that the mixing process you have developed meets the technical parameters of the mashing machine.
2. Excessive charging or too long mixing time will not achieve the desired process effect. The ice meat chopping machine should be especially cautious. It is recommended that you first turn the block into pieces when you mix the ice meat, or Mix half-thawed small pieces of meat and avoid large pieces of iced meat to avoid damage to the knife.
3. During the use process, always check the lubrication of each part, the tightness of the bolts, etc. The boring tool should be repaired or replaced. After the replacement, install it in the original order, and tighten the nut to the left wire.
4. Proper and reasonable use of mixing opportunities to extend the life of each part