Warm Tips: 

We can supply most of the manufacturers of filter accessories, complete model, the goods quickly, quality assurance.

Limited space, not one by one show, if demand, please contact, thank you!

Air filtration, liquid filtration, gas filtration, hydraulic oil filtration, petroleum filtration, 
dust filtration, coalescers, separators - we can all produce!
No matter which brand - we can produce!
No matter which model - we can produce!
You have needs - please contact us.

 Filter elements have been designed to 99.999% DOP efficiency on .2 micron diameter particles. They are rated at 5 parts per million at 60 Torr maximum carryover.  Oil mist filters are designed for oil mist, pretty large molecules. If you are dealing with volatile solvents or other types of work place unfriendly items then the second type of exhaust filter is the filter for you. These types of filters usually entail a little more installation cost due to need to run hoses from pump exhaust to the hood but because they present a closed loop to the hood for exhaust the user is assured a clean environment.

Filters will require changing from time to time and the frequency depends on the amount of use the filter element in the filter gets. A simple maintenance program can be put in place once the frequency of actual changes needed becomes apparent. If a filter is allowed to operate after being all clogged up over time, then back pressure may start to develop in your pump and may put undo pressure on the shaft seals or other exit ports from the pump itself. The motor will also tend to work harder in this situation, so it is important to replace the element every 6 months or so. Again it really depends on the amount of use the system gets. Filter change out generally should occur when there is a pressure differential of 2.5 psid across the filter.

All of the exhaust filters from  are very easy to install and either thread into the exhaust port of the pump or can be clamped on in some relatively simple manner.

 Depending on what you are pumping out of your system a good exhaust filter, with a port to a hood may be a prudent investment. Your pump has less of a chance of running out of oil with this type of item in place. There is less exposure for local personnel to the exhaust by products and vapor streams from the pump. It is feasible to port the exhaust directly to a hood, but then monitoring of the pumps oil level should be made a routine preventative maintenance practice. Take care to avoid any low spots in the exhaust line as oil may collect there and again cause back pressure during operation.

Other causes besides external leaks and operating the pump open to atmosphere are what are known as virtual leaks. If the pumps exhaust valves are not working correctly then excess oil mist may also appear in this manner. To check if this is the problem, disconnect your pump and place a rubber stopper in the intake port and turn the pump on. If the pump goes gurgle, gurgle and quiets right down this is how it should sound. Try actuating and making sure the gas ballast valve (knob on top of the pump) is seated in the down position. If instead, after playing with the rubber stopper for a couple minutes, the gurgling has not gone away, then it is best to give us a call.

The two types below show regular exhaust filters which vent to atmosphere at your using location and capture filters which have threaded fittings to allow the capture of exhaust stream from the filter itself.  It is then possible to port this stream to a hood or out of the building.

We offer an extensive cross for the following brands

Our filtration equipment is used in a wide range of industries:

Advanced production process: