LBW1800PB Vertical Glass washing and drying machine

The machine has glass feed section, glass washing and drying section, light inspection section.

2. The first section is equipped with LOW-E glass check system. When the coated side is wrongly put, the system will give alarm and the convey will stop automatically.

3.Three pairs of brushes driven separately by 3 motors. Brushes thread are imported soft material, special for LOW-E glass.

4. Washing section uses SKF brand oil-free and water-proof bearings. It will not cause second contamination to glass.

5. Static electricity remove device is equipped at the end of washing section. It can remove the static electricity of the glass so the dust will not fall on the glass.

6. Washing speed is controlled by an inverter.

Secotion1: Feed Section:

The back board is high density board with film

  It is the first section of the line and its main function is to transmit the glass to the washing and drying section. The transmission is carried out by chains driven by the motor and the transmission speed is stable. It runs at the same speed of the washing and drying section and the speed can be changed by the inverter. It can avoid the back board bending and deformation, also can waterproof, avoid acid-base.

 LOW-E glass automatic diagnosis system: it can easily know whether low-E glass putting is right or not. When is wrong, the alarm will raise the alarm, and worker can change it immediately. This system prevents the membrane of coating glass (especially the LOW-E glass) from being destroyed, the glass input conveyor station is loaded with the coating glass automatic diagnosis system, fully guaranteed the correct washing and covering of the coating glass.

Low-E glass automatic diagnosis system

Section2:Washing and Drying Section

Washing part: This part has three pairs of brushes (the material is high -temperature nylon wire ) and a pair of sponge roller. The brushes are driven by three synchronous motors separately and the movement is stable. Three pairs of tubular rollers type of hair brushes, use High Temperature Resistant and soft nature hair brush, fully guaranteed the coating glass especially the LOW-E glass layer stratification can’t be destroyed.

Brushes (high-temperature nylon wire)

1. It adopts custom-made and imported nylon, front is three pairs of soft brushes(Φ0.10mm), back is three pairs of hard brushes(φ0.15mm),it last the brushes life.

2. According to the glass thickness, automatically control the spacing of the drag roller, it doesn’t need any other manual adjustment for the glass that have different thickness in the adjustable scope by bearings.

Bearing is SKF from Sweden

Can automatically adjust space of drag roller according to glass thickness

3. The washing and drying section adopts stepped frequency conversion governor, which make the glass run at the appropriate speed stably.

Drying part: the air enters into the air knife from the top. The distance between the air knife and the glass should be adjusted according to the thickness of the glass in order to guarantee the drying effect. Air passage adopts the most advanced design and increase the drying speed and productivity.

Stainless steel wind knife

1. There is a pair of rhombic air knife, the front air knife can adjust backward or forward according the glass thickness. The blower, which is equipped with heater, blows strong hot wind; also it is equipped with infrared heater that can dry the both sides of the glass quickly.

2. The dry section uses the high quality stainless steel, all of them are anti-corrosive material (including air knife, transfer gantry).

Section3: Transition and Unloading Section:

This section is used to transmit and store the glass to improve the work efficiency Light inspection is equipped with a foot switch. You can stop the convey and check the washing quality.

Technical parameter:

Main Parts Brand