BYT Clear Coat Series
Extra Fast Clear Coat
Product Name/Model：BYT Clear Coat Series
Characteristic:
1、 BYT518 Clear Coat ：Two- component 518 clear coat with super-high density and solid,deep rich gloss, high hardness, excellent weathering and chemical resistance. Applies to senior cars, suitable for overall refinish, quality and performance compare favourably with many imported clear Coats
2、 GH418 Clear Coat：Two-component fast drying 418 clear coat with excellent gloss, high hardness, excellent weathering and chemical resistance.
3、 LA318 Clear Coat：High gloss 318 clear coat, with high richness, good levelling property, easy construction, high hardness, excellent chemical and weathering resitance. Be paint film in lower temperature. Application in Medium, Senior car, MPV, Bus.
4、 BYT228 Clear Coat：High gloss and high hardness two-component 228 clear coat, easy construction, fast dry, good pretective power and weathering resistance, save cost and time during refinish.Application in standard car, construction machinery.
Substrates | 1K Basecoat. | ||||
Mixing Ratio | Clear Coat | Hardener | Thinner | ||
2 | 1 | 0.2-0.5 | |||
＜15℃ | Clear Coat | Mating Fast Hardener | BYTX-1 Fast Thinner | ||
15-30℃ | Clear Coat | Mating Standard Hardener | BYTX-2 Standard Thinner | ||
＞30℃ | Clear Coat | Mating Slow Hardener | BYTX-3 Slow Thinner | ||
Spray Viscosity | 16-19s to drop off, in 4# viscosity cup at 25°C, | ||||
Pot-Life | At 25℃ | ||||
ReTreatment | There are particles or runs after spray, sand affected area with P2000 sand paper | ||||
Spray Gun Set Up | Gravity Feed: 1.2-1.5mm 4-5kg/cm 2 | ||||
Spray Technology | Coats&Thickness: 2-3 coats, total 25-35um | ||||
Drying Time | Temperature | Dust Free | Tack Free | Dry to Handle | Dry to Test |
25°C | 30 minutes | 2 hours | 8 hours | 6 days | |
70°C | 5 minutes | 10 minutes | 25 minutes | 60 minutes | |
Shelf Life | 2 years in original sealed can, cool and dry place at 20℃. | ||||
Package | 5L×4 or 2.5L×8 or 5L+2.5L+1L | ||||
Note:
1. At temperature lower than 15°C, air-dry at ambient temperature is not recommended. Better to allow a full bake at 60°C.
2. At ambient temperature higher than 30℃, add appropriate Retarder Solvent into thinner to avoid blushing. For more details, please refer to technical data sheet of Retarder Solvent.
3. The products mixed with hardener should be used up soon and can not be restore for future use;clean equipments immediately with thinner after application, otherwise it is very difficult to be cleaned after dry.
