About Dahan vibration vibration screen
DH series shaker products, years of use by the customer, get a lot of first-line feedback suggested that in its own mature manufacturing technology, based on the screening machine, Han mechanical engineers to meet customer demand for standard , several technical improvements, screening effect is more superior, a "generic" new power shaker, three-dimensional power more prominent, wider scope, Han machinery company can design special models based on customer needs, whether the material is dry is wet, is fine is rough, is more than significant is the proportion of light, 0-400 mesh can be screened, whether liquid or slurry of 0-600 mesh can be filtered. "Han" vibration sieve series equipped with a special screening net cleaning device, the blocking net rate to a minimum, over the net rate and processing accuracy can be effectively improved. "Dahan" have the ability to manufacture special models allow customers to "Han" There are more choices. 

Using the industry: 

Chemical industry: resin, paints, industrial chemicals, cosmetics, paint, medicine powder. 

Food industry: sugar, starch, salt, rice flour, milk powder, milk, egg, soy sauce, fruit juice. 

Metal Mining: aluminum powder, lead powder, copper powder, ore, alloy powder, welding powder, manganese dioxide, copper powder, magnetic power, abrasive powder, refractory materials, kaolin, limestone, alumina, carbonate, heavy calcium, silica sand. 

Pollution treatment: waste oil, waste water, wastewater dyeing, additives, activated carbon, etc.

Shaker features: 

☆ high efficiency, compact design and durability, any powder, mucus can be screened. 

☆ Changer easy, simple operation, easy to clean. 

☆ mesh is not blocked, the powder is not flying, can be screened to 400 mesh or 0.028mm. 

☆ impurities, coarse material discharged automatically, continuous operations.

Shaker installation and commissioning

1.  Equipment shall be the basis of stability. When the equipment is installed on the general ground or cement foundation, you can not set the anchor bolts. When the equipment is installed on top of the steel structure of the gantry, the application bolt on the structure, but there should be a steel gantry steel degrees. 

The machine only a three-phase switch (Note: It is best to use electrical control panel), with snakeskin pipe threading, the motor can be connected to the power supply, that the electrical control panel should be installed on a wall hanging. 

2. The factory (two) devices will screen installed properly, the process of using a screen replacement may themselves be replaced. 

Before (three) boot, you should first check the tightness of all bolts, and whether various spout position catcher on the positive, and see if the vibration motor can rotate properly and the spring force or without obstacles, check the layer mesh are pressed. 

3. Before vibration sieve access electrical control panel, you should first check the electrical control panel. Line after turning observe whether the vibration motor rotation direction is clockwise (Note: otherwise should change the phase sequence) is functioning properly, there is no different noise. 

4.  Adjusting the phase angle of the upper and lower eccentric vibration motor block to accommodate a variety of materials screening situation.

If you are interested in our products,you can contact me.