Main Products: 
fluorite dryer
Negotiable /Bag
Min.Order:1 Bag
Product Details
Fluorite dryer introduction:
The material is sent to hopper by belt conveyor or bucket elevator, and then enter into the feed end by the charging pipeline of the charger in hopper. The charging pipeline gradient of fluorite dryer equipment should be bigger than the natural gradient of material so that the material can enter into the dryer smoothly. The dryer cylinder is a spin cylinder of little tilt to the horizontal line. Material goes in from the higher end, the heat-carrying agent enters from the lower end contacting with the material in countercurrent way. The wet-material is heated directly or indirectly by the heat-carrying agent during its moving forward process in the fluorite dryer equipment, and thus it is dried. Then it is sent out by belt conveyor or spiral conveyor on the discharge end. There is shoveling plate on the fluorite dryer inner wall, lifting and dropping the materials to enlarge the contact surface of material and air current and speed up the drying process and promote the material moving forward. The heat-carrying agent can be divided into hot air and flue gas. After the heat-carrying agent entering into the dryer, cyclone collector is needed to gather the material in the air. To further reduce the dust load in tail gas, the bag filter or dust washer is needed.
You May Like
New Products
Recommended Products
Find Similar Products By Category
Facebook
X
Pinterest
Linkedln