Delivery Time:10-15 working days after receiving the deposit
Certification:ISO9001

High Strength Steel Rebar Upsetting Machine Professional Simple Operation​

Features:
 
1. High strength: the strength reach Grade I , stronger than the reinforcement bar
and guarantees bar break under tensile stress
(tensile strength of connection point =1.1 times of connected bar).
 
It can satisfy the requirements stipulated in the Chinese standard JGJ107-2003,JG171-2005.
 
2. Wide working range: adaptable for 16mm-32mm same diameter, different diameter, bending, new and old, advance covered up rebar of GB 1499 , BS 4449 , ASTM A615 or ASTM A706 standard.
 
3. High efficiency: upset forging and threading one joint only needs no more than one minute, and handy operation and quick link.
 
4. Environmental protection and economy profit: no environment pollution, can work all day, not affected by weather, economize energy source and bar material.

Main Technical Parameter
 

Process Range	Rebar of Φ16—Φ32
Motor Power	Y132M-4 7.5KW
Power Supply	Three-phase four-wire 50HZ
Hydraulic Pump	10MCY14-1B 31.5MPa
Hydraulic Oil	68# hydraulic oil
Weight	1000KG
Size	1250×850×1650mm

     
Structure
 
 The machine include machine tool, press oil cylinder, forward oil cylinder, main body, mould and upset head, electrical control system, hydraulic system.

 
   
     
 
 
Operation
 
1- Installation

       After the mold is installed, reset the stroke limiting bracket. Adjust the travel limit screw so that the stroke control in 15mm, insert the test steel bar to the top of the mold center hole press automation button. After the processing of the work-piece, measurement it. If failed, then adjust stroke limit screw to make the trip gradually increased, until processing of qualified products.
       
2- Safety operation rules

1. Workers have to be trained and tested OK then can work.
2. Before operation with rebar, first running the machine 2-3 mins without processing, if it is running normally the process.
3. The feeding head of head should be plain and straight.
4. Before processing the rebar, the machine should be reset and then process
to ensure the same processing.
5. The processing rebar can not have the transverse cracks, when the equipment break down should be eliminated timely.
6. Oil should be 68# hydraulic oil.
7. Workers should obey the safety rules
 

3- Machine Failure and Exclusion 

Trouble phenomenon	Reason	Method of exclusion
No action of cylinder	Motor reverse	Swap two-phase power supply
	Electromagnetic spill valve failure	Replace the electromagnetic spill
	Low oil level	Add hydraulic oil
	Residual air in cylinder	Empty run 3-5min
The cylinder can only run in one direction or the oil cylinder nonstop	Solenoid valve Cards	Find professional repair person
Die of steel	Die wear	Change mold
	Small pressure	Professional Surge
Mold cracking	Too much pressure	Replacement of mold, professional regulator
Upsetting head is not full	Screw stroke wrong location	Adjustment