Original Open Debugger Board Burner Module Banana pi G1 development board with Wifi CC3200 &bluetooth CC2540 modem zigbee gateway super raspberry pi zero
USD $59 - $59 /Piece
Min.Order:100 Pieces
Introduction:
Open Debugger is a set of programming tools in the development of STM series of microcontrollers, TI CC1x, 2x, TI CC3x series SOC, when STC Series MCU can be programmed quickly and easily debug, debugging programmer does not have to do something different series of chips switching plug tedious work.
In addition, it also integrates a USB to serial port, which is a common interface for embedded development.
It is also one of USB2.0 HUB, making it easy to extend to other USB tools.
With it, no longer need to face a bunch of different writer, complicated mess of wiring, USB port deficiencies.
Operating Condition:
Operating voltage: DC 5V
Operating temperature: 0°C to 85°C
The onboard voltage output: 3.3 V
Maximum output current: 2000 mA
Supported operating systems:
Microsoft Windows 2000
Windows XP SP2/SP3 operating system (32-bit versions)
Windows Vista operating system (32 and 64 bit)
Windows 7 operating system (32 and 64 bit)
Windows 8 operating system (32 and 64 bit)
Support Objects:
a)CC Debugger Interface:
Programming and debugging of the following 8051-based TI SoCs:
CC1110, CC1111
CC2430, CC2431
CC2510, CC2511
CC2530, CC2531, CC2533
CC2540, CC2541
CC2543, CC2544, CC2545
Control the same apparatus to SmartRF Studio. In addition, you can also control the following transceiver SmartRF:
CC1120, CC1121, CC1125, CC1175
CC1100, CC1101, CC110L, CC113L, CC115L
CC2500, CC2520
It can also be used to program the PurePath wireless devices:
CC8520, CC8521
CC8530, CC8531
b)SWD Interface:
Programming and debugging mainstream ARM7 9 11, Cortex-A5 A8 A9 M0 M1 M3 M4
Supported MCU manufacturers:
ST, Freecale, Nuvoton, NXP, TI, Cypress, Atmel, Analog, Fujitsu, Toshiba, Energy Micro...
Speeds up the programming and debugging functions 4Mhz: Write Flash Rom, EEPROM, ARF, and support for full speed, stepping, breakpoints
c)JTAG Interface:
JTAG programming and debugging interface for all supported kernel.
d)UART Interface:
STC series microcontroller programming and debugging output port for printing information.
Package included:
1 x Original Banana Pi G1 Open Debugger