Delivery Time:20 work days
Certification:ISO9001:2008
Production Description
Main-vice Desulphurization Wet Scrubber is made of carbon steel and lined with granite. Several modules are separated and assembled at site. (Or made as a whole steel-made tower and lined with granite.) The gas after dedusting enters into the desulphurization tower, and the SO2 containing in the flue gas is purified due to neutralization reaction. The vice tower has the function of dehydration in order to protect the ID fan, flue and chimney that connected after the vice tower.
Principle of Operation
Desulphurization spray layer is based on the upper part of the tower, the absorption tower slurry circulating pump corresponding to each spray layer. The nozzle configuration of spray layer is simulated designed by professional software in order to ensure good contact with alkali and acid reverse gas reaction; and finally reach purification effects. Demister installs in the upper desulphurization tower, a total of two levels. The net is used to separate the entrainment of flue gas cloud droplets, and droplet concentration in flue gas export from mist eliminator is less than 75 mg/Nm3 (dry basis). At the same time, the equipment also has spray washing device to the tiny dust particles adhesion and desulphurization of flue gas crystallization on the demister system resistance increases.
Notice After Starting ID Fan
| Notice After Starting ID Fan | |
| a | Open the adjustment door gradually to the normal situation after starting the fan. The temperature of the bearing cannot exceeds 40℃ over the environment during operation. |
| b | The test run of the fan should under no load condition (close import tube adjustment door). |
| c | If the testing running works well, work under full load (specified total pressure and flow) |
| d | No less than 2 hours under full load operation. |
Operation
1. Firstly, please turn on pump, turn off the door of induced fan, reduce current. Then, open the door of the fan when the fan operates normally. At last, when there is water overflowing at the outlet of water spray tower, please turn on the induced fan.
2. When operating, please observe the operation of water supply system and ensure water supply even and normal.
3. When operating, it is not allowed that there is no water in cylinder. Please check whether the outlet of ash water is smooth regularly and observe the temperature of flue gas and resistance of system.
4. When operating, PH value of water in tank should be tested regularly, when PH value is less than 7, alkali matter should be added to ensure the PH value of circulating water.
5. According to the amount of ash, mist eliminator backwash pump does not need to operate for a long time, it should be controlled well.
6. Water level in processing water tank should be normal before turning on backwash pump. Water level in circulating water tank should be normal before turning on circulating water pump as well. If the water level cannot achieve the requirement, please start clarified water pump so that water in processing tank can flow into circulating tank, as a result, water level in processing water tank is of importance.
7. When turn off device, please turn off induced fan firstly and then water pump.
8. If the device has been rested for a long time, there is necessary to drain water in water pipe and tower and clean up the ash in multi cyclone dust collector.
