Delivery Time:20 work days
Certification:ISO9001:2008
Production Description
Integrated Desulphurization Wet Scrubber is made of carbon steel and lined with flake resin (or granite). The tower can be manufactured in the factory and transport as a whole if the diameter of the equipment is below 5.5m; while the diameter of the equipment is above 5.5m, the tower should be manufactured at site. The integrated desulphurization wet scrubber has the advantages of lightweight and short period.
Types of wet Scrubber Spray Tower
Single Desulphurization Wet Scrubber
Main-Vice Desulphurization Wet Scrubber
Integrated Desulphurization Wet Scrubber
Transportation
Operation
1. Firstly, please turn on pump, turn off the door of induced fan, reduce current. Then, open the door of the fan when the fan operates normally. At last, when there is water overflowing at the outlet of water spray tower, please turn on the induced fan.
2. When operating, please observe the operation of water supply system and ensure water supply even and normal.
3. When operating, it is not allowed that there is no water in cylinder. Please check whether the outlet of ash water is smooth regularly and observe the temperature of flue gas and resistance of system.
4. When operating, PH value of water in tank should be tested regularly, when PH value is less than 7, alkali matter should be added to ensure the PH value of circulating water.
5. According to the amount of ash, mist eliminator backwash pump does not need to operate for a long time, it should be controlled well.
6. Water level in processing water tank should be normal before turning on backwash pump. Water level in circulating water tank should be normal before turning on circulating water pump as well. If the water level cannot achieve the requirement, please start clarified water pump so that water in processing tank can flow into circulating tank, as a result, water level in processing water tank is of importance.
7. When turn off device, please turn off induced fan firstly and then water pump.
8. If the device has been rested for a long time, there is necessary to drain water in water pipe and tower and clean up the ash in multi cyclone dust collector.
Installation Statement
| Installation Statement | |
| 1 | After ensuring the position of desulfurization spray tower, infrastructure should be covered normal mortar, the horizontal position should be found after installing the first section according to the number of each section. |
| 2 | Please ensure the consistency between inlet center of the device and the boiler outlet duct center. The connection should be smooth to reduce the resistance of the system. |
| 3 | When hoisting one section, rub the furan resin daub dispatched together with the equipment and then apply furan powder as well as furan resin daub at a ratio of 2.5:1. Then stir and pave them evenly on the annular face of the shell, about 1 to 2 cm thick. When stirring the daub, we shall control the time. |
| 4 | After acid-proof mortar is used to connect sections, joint should be filled with furan resin daub. |
| 5 | Spray pipe, mist eliminator, back washing pipe should have been installed. If somewhere need to be welded, please pay attention to falling sparks to light up mist eliminator. |
| 6 | After the completion of hoisting the whole equipment, daub shall be used to fill full the notch of each section connection and build a slope that is inclined in a downward way so that the rain dew will not accumulate at the seams of the equipment under outdoor environment. |
