Panel 8 integrating passive POE injector suitable for powering up to eight devices.
The RJ45 connectors on one side are connected Ethernet ports with no power (switch) on the opposite side of the device used to connect power for Ethernet cable.
Are used to power the two unused pairs of the
Ethernet cable.
Power couples: 4,5 (positive pole) / 7,8 (negative
pole)
Parameter
Input | DC12~48V |
Output | 12V~48V DC |
Power + Data out | 1/2 & 3/6 for Data, 4/5(+) & 7/8(-) for Power (48V) |
Data In | Connects PC/HUB/Switch |
Data Rate | 10/100 Mbps |
Ethernet Cable | TIA/EIA 568 Cat.5 |
Connector | RJ-45 |
Operating Temperature | 0°C~40°C |
Storage Temperature | -40°C~70°C |
Operating Humidity | 10%~80%RH |
Storage Humidity | 5%~90%RH |
The poe injector does not include the power supply.
The power supply is sold seperately.
Use/ Application:
·IP Security Cameras
·Network routers
·A mini network switch installed in distant rooms, to support a small cluster of ports from one uplink cable. (These ports on the mini-switch do not themselves provide PoE.) (In most modern VoIP phones a two-port switch is embedded to which a local workstation can be installed using a different VLAN from the voice-VLAN used by the phone itself)
·Network webcams
·Network Intercom / Paging / Public address systems and hallway speaker amplifiers
·VoIP phones
·Wall clocks in rooms and hallways, with time set using Network Time Protocol
·Wireless access points
·Outdoor roof mounted radios with integrated antennas, 802.11 or 802.16 based wireless CPEs (customer premises equipment) used by wireless ISPs.
·Industrial devices (sensors, controllers, meters etc.)
·Access control and Help-points (intercoms, entry cards, keyless entry, etc.)
·Lighting controllers
·Remote Point of Sale (POS) kiosks
·Physical Security devices and controllers
