Product Details

Delivery Time:7-25days
Certification:CE ,ISO

Name :

single cylinder 4-stroke air cooled diesle water pump for use

Specification :

Model	YMDP20
Pump type	Diesel Water Pump
Inlet/out Diameter(mm)(in)	50(2’’)
Rated Flux	22
Rated Lift	15
Self-Priming time(s/4m)	80
Max Suction(m)	8
Speed(r/min)	3600
Noise Level [DB(A)/7m]	74
Match Diesel engine	YM170
Rated Power	2.8KW
Fuel Consumption(g/kw.h)	288
Displacement(cm³)	211
Start Method	Recoil /Manual Start
Diesel engine type	Single cylinder,Air cooled ,4 stroke ,Direct Injection Double Bearing
Lubricating Method	Combined Pressure &Splashing
Fuel Capacity(L)	2.5
Bore*Stroke(mm)	70*55

Diesel Engine Picture:

Diesele engine with electric starter system :

1. The prepraration of the diesel engine for the electirc starting system is the same as the

manual recoil type:

a: open the fuel cock

b: Set the sped govemor level to the atart position

c: Turn the start switch clockwise to the "start" position

d: if the engine is start,immediately remove your hand away from the key switch

e: if the engine does not start after 10 seconds,wait awhile(about 15 seconds) before trying to

start the engine again

our Diesle powered displacement pumps have some of the following features:

1. Lightweight construction

2. High pressure aluminum alloy construction

3. Hard working four-Stroke disel internal combustion engine

4. Large fuel tank

5. High quality machanical seals

6. Self-Priming structure

Trouble shooting

Cause	Remedy
Not Enough fill water	Refill the pump with water
Leaking inlet pipe	Check the inlet pipe and connector of the pipe ,change pipe or tighten the clipper joint screw
Low pump speed	Adjust the engine speed accordingly or find cause within the engine
The filter net is clogged	check the position of the pump and fix the operating conditions as specified
Seal wear and leakage	Change the seal
The filter net,pipeline,or impeller is clogged	Clean out the clogging matter
Speed is low	Increase speed
Leaking inlet pipe	Check the inlet pipe and connector ot pipe,change pipe or tighten the clipper joint screw .