Delivery Time:2 weeks
Certification:CE

Tunnel Type Powder Coating Oven Insulation With Electrical / Gas And Diesel Fired

Tunnel Type Electrical , Gas Powder Coating Oven With Welded Or Modular Construction

Quick Detail:

1. Welded or modular construction with high quality M.S Sheet

2. Hot air circulating blower for uniform heat

3. High quality insulation (Glass/mineral wool) to eliminate heat loss

4. Electrical,gas& diesel fired (heat exchanger)

5. Digital temperature controller with auto on/off or manual

below data just for certain project case

number	item	data
1	External size:	L25×W1.25×H4.92mm(the rail top elevation)
2	Internal size:	W1.15×H2.55m
3	mode of  drying tunnel:	Full bridge mode
4	Thickness of the insulated board:	Side plate:120mm, roof/bottom plate:120mm
5	Inner and outer plate of insulation layer	Internal plate:δ1.omm galvanized board, outer plate:δ1.omm cold plate
6	Wind tube	δ 1.0mm galvanized board
7	Natural exhaust device:	1piece
8	Effective drying length:	About 40m(except the length of climbing section)
9	Baking time:	About 20 min
10	Heating time (empty furnace)	about45min
11	Heating temperature:	180～220℃ adjustable
12	380000cal burner	1piece FS38
13	380000cal heating box	1set(outer plate:δ1.0mm cold plate, internal plate:δ1.0mm galvanized board)
14	Heat induced draft fan	4-72NO6A,1450r/min,4KW,2pieces
15	380000cal heat exchanger	High temperature resistant stainless steel, quantity:1set

tunnel type powder coating curing oven system:

Whether electrical, gas or diesel fired. Whether batch type or conveyorized tunnel type. Designed and built 

specially for Powder & Liquid curing purposes assuring you of low power consumption with uniform 

temperature throughout the working space in the oven.

Melting & Curing constitutes a highly critical phase of the powder coating process. The curing schedules 

recommended by the powder or liquid supplier must be strictly followed, if good adhesion & corrosion 

resistance is to be achieved. While powder melts at approx.100°C, curing requires higher temperatures 

usually between 180°C to 200°C.If the curing is inadequate, the quality will be brittle and flake-off easily. 

If the powder coat is exposed to harsh heat its colour may change. 

Construction:

Welded or modular construction with high quality M.S Sheet

Hot air circulating blower for uniform heat

High quality insulation (Glass/mineral wool) to eliminate heat loss

Electrical,gas& diesel fired (heat exchanger)

Digital temperature controller with auto on/off or manual 

Asbestos gasketing, flap sliding doors

Perfect locking arrangement and heat resistant paint(in side)