Delivery Time:25-30 working days
Certification:CE/ROHS/REACH/WEEE/EMF

Touch Button 180WS Digital Studio Flash Light Photography Equipment for Back Light source 

QUICK START GUIDE

Mounting on the light stand
Select a stand or support system of suitable weight and dimensions to ensure stable operation of the unit. Fitting the modelling lamp and flash tube
Check that the modelling lamp voltage is correct.
Ensure that the unit is switched off and disconnected from the supply. Confirm that the lamp and flash tube are securely fitted, particularly before first use or after transporting the unit. Connect the sync cord to the socket (10). Power supply connection
Be sure that the power switch (6) is set to OFF. Use the cable equipped with the unit to connect to AC supply. A 3-wired, grounded supply system should be used for safe reason. Adjust the Flash/Modelling lamp to provide the desired settings and select any options by pressing the switch.

Now you can start to use the unit.

SPECIFICATIONS

Type	M180
Power Output	180WS
GN (ISO 100)	40
Power Setting	From 1/16 to Full (0.1f-stops/step)
Recycle Time to full	0.3~2.3s
Flash Duration	1/1500~1/600s
Modelling Lamp Output	75W (Diffused Halogen)
Flash release	Slave Sensor(cell)/Synch Cable/Test Button
Ready display	Visual and audible signals when 100 % of selected energy is reached
Color Temperature	5600K±200K
Flash Beam Width	55°
Flash Tube	Plug-in Flash Tube (easy replaceable)
Synch Voltage	5V
Cooling	Natural cooling and Temperature sensor protection
Power Source	AC200V-240V 50Hz/60Hz
Amperage of Fuses	5 A
Dimension (L x W x H)	45cm x 21cm x 27cm

CARTON CONTAINS
 

180WS Flash Body   1pcs 75W Modeling Lamp  1pcs Power Cable      1pcs Synch Cable      1pcs Instruction Manual  1pcs

 FLASH CONTROLS AND OPERATION

The flash power is adjustable over a 4 f-stop range (5 f-stops) from 1/16 to full in 1/10 increments using the Power regulator down (12) and Power regulator up (11) push buttons. The power is displayed in an easy to use decimal form where each whole number represents 1 f-stop. The control has a minimum setting of 2.0 and a maximum setting of 6.0. A single press of either the UP or DOWN button changes the value by 0.1f-stop (1/10) to give a total of 50 values. (E.g. If the current value shown is 5.4, then to reduce the power by 1 f-stop just reduce it to 4.4.). With a long pressure on the energy control keys \"up/down\", the setting changes in intervals of ten. The Table as follows shows the whole decimal numbers and equivalent fractional power ration:

Displayed Power	Fractional Equivalent
6.0	Full
5.0	1/2
4.0	1/4
3.0	1/8
2.0	1/16

Note:

When you adjust the power range from higher GN to lower, the unit will be triggered automatically to flash for discharging and then recharge until the GN you displayed.

CONTROL PANEL DIAGRAM

 
CONTACTING INFORMATION
 

E-mail: info@simockphoto.com.cn

            amandalee@simockphoto.com.cn

Skype: amanda_cn

Contacting: Ms. Amanda Lee (Export Manager)