-high flexibility
-SGS and ISO9001:2000 certified.
-Rubber air springs, such as Sleeve air springs, Single/Double air spring .

H series Air spring:
BELLOWS : Wall gauge is approximately 5 mm.
GIRDLE HOOP: Wire wound type shown, molded into the bellows.
BEAD RING: upper and lower. countersunk steel type shown. May also be of a second stamped steel variety or made of aluminum.
AIR INLET:  1/4BSP parallel is standard. 3/4BSP parallel is also available for most parts.
BOLT: M10 x 45 mm Used for mounting the part.
MOUNTING PLATE:  The plates must be strong enough and backed by structural members to prevent bowing of the forces or loads involved

 

K series Air spring:
BLIND NUT:  M8 x 15 (two or four per each plate depending on part size). Used for mounting the part.
MOUNTING PLATE:  The plates must be strong enough and backed by structural members to prevent bowing (of the forces or loads involved.
AIR INLET:  1/4BSP parallel is standard. 3/4BSP parallel is also available for most parts.

ZF series Air spring
BLIND NUT:  M8 x 15 (two or four per each plate depending on part size). Used for mounting the part.
MOUNTING PLATE:  The plates must be strong enough and backed by structural members to prevent bowing (of the forces or loads involved.
AIR INLET:  1/4BSP parallel is standard. 3/4BSP parallel is also available for most parts.

 

CY series Air spring
BLIND NUT: M8 x 15 (two or four per each plate depending on part size). Used for mounting the part.
AIR INLET: 1/4BSP parallel is standard. 3/4BSP parallel is also available for most parts.