Two independent channels.
Microprocessor control with auto-stop function after batteries full charged.
The LEDindicator shows
Technical Parameters:
Input Voltage:
AC 220V 50Hz
Charging Output:
AA/AAA 1.2V ×2 90-120mA
Operating Temperature: 0-35°C
Charging Time(see Table 1)
Table 1
Type | Model | Battery(mAh) | Charging Time(h) |
Ni-MH Ni-CD | AAA | 600 | ≈7 |
700 | ≈8 |
||
AA | 1300 | ≈15 |
|
1600 | ≈19 |
||
1800 | ≈21 |
||
2100 | ≈24.5 |
||
Alkaline battery | AA | 1500 | ≈16.0 |
AAA | 1000 | ≈10.8 |
Usage Instructions:
Connect the charger to socket (make sure the input voltage is correct), the RED LED will be glitter three times, the battery charger stand by for charging.
According to anode and cathode, put the battery in correct slot, the corresponding LED will be glitter slowly. Enter into the charging status.
When the LED stop glitter that means the batteries are full charged.
Take out the battery when fully charged.
Safety Precautions:
Please do not charge the Alkaline or Carbonic battery more than 3 times. Otherwise it may cause battery leakage.
For indoor use only. Do not expose charger in rain, high temperature or moisture.
Always unplug the charger from outlet before attempting maintenance or cleaning.
It is normal for batteries to become hot during charging and they will gradually cool down after fully charged.
Charger operation temperature: 0~35°C.
Special Emphasis:
Please read the instruction carefully before using lest for the charger damage if improper use.
If batteries are stored and not used for more than one week, recharge them before use.
