auditorium acoustic panel

und absorption
2.good decorate effect
3.human friendly
lamine surface

1.excellent acoustic performance
2.good decoration effect 
3.improving sound articulation 

Detailed Product Description

1.Core material: MDF board

2.Thickness 12/15/18/25mm

3.Surface: melamine / wood veneer with natural wood veins for over 100 colours

4.Black felt: noise reducible element.

5.Size:600*600mm/600*1200mm

6.Low formaldehyde emission, conforms to E1 Standard of Environmental protection

7.The product is qualified for the highest fireproof of Class B1. It has passed National Fire protection Authority.

8.Easy to install.

9. widely used in Hotel, Dinning Room, Shopping Center, Theatre,Dancing Room,Cinema, Station, meeting room, Office, Airport, villas and residential areas etc.

installation:

1,PREPARING

1)constructing location: keep dry, the temperature should be higher than 10\'C, the widest humidity range should confined to 40%-60%

after construction 24 hours before constructing, the location should reach the standards as above.

2)acoustic panels: for the acoustic panels accommodated to the circumstance of constructing, please place the panels in the

constructing location for 48 hours, check up the type, specification and amount of the panels before constructing.

3)keels: fix the keels on the wall flatly according to the plan, the keels should be flat, slick, no rust, no metamorphosis; the

wall must be construct according to the standards, the keels suitable install with acoustic panels, leave smaller than 500mm space

between each wooden keel(smaller than 600mm of light steel keel), install the keels vertically with acoustic panels.

2,FIXING

1)siz of wall: all panels should be installed in accordance with the manufacturers recommendations.

2)cutting: all necessary hardware and accessories for a complete job installation are to be furnished by the contractor.

3)install the acoustic panels: the installation of acoustic panels should be carried out in a sequence from the left to the right,

from upside to downside, the panels are cut to fit on site, traditional woodworking tools are suitable for cutting the panels, if panels are cut using a fine tooth table saw the panels should be cut face up to avoid scratching and at a much slower speed to avoid any tearout or chipping.

 4)fix on keel:

1)wooden keel fixing using nails, staples or screws into prefixed timber battens on the walls via the tongue and groove joint.