SFSP998 Tear Circle Hammer Mill Grinder Machine

Re: The above indices are those when meeting the following conditions: raw material: corn, moisture content not higher than 14%, density not lower than 0.72t/m3, screen: hole diameter ￠3mm, hole-opening rate not less than 33%.

◆The grinding chamber is of tear circle shape, effectively eliminating the circular flow in the grinding process and getting higher capacity;
◆The Bottom of grinding chamber is fitted with U-shape double grinding structure, further improving the capacity with evener particle size;
◆Rotor passes accurate dynamic balancing test, resulting in low equipment noise and smooth running.
◆Both coarse and fine grinding is realized through adjusting the gap between beater and screen;
◆New type S shape coupling directly connecting driving results in big offset travel and effectively avoid the heating of bearing;
◆Beater blade edge is vacuum-welded by special alloy steel, resulting in long service life;
◆The imported products are used for key parts, resulting in long service life and low maintenance cost;
◆The moving full-wide operation door facilitates maintenance and replacing of beater;
◆SFSP998 Tear Circle Hammer Millis widely used in various feed mills, oil plants, alcohol plants, citric acid plants, etc.