Delivery Time:10 working days
Certification:IS09001：2000
Grout Adhesive Mosaic Tile Adhesive Eco Friendly For Bathroom

Product Name	PB-FTJ Waterproof Grouting Adhesive (3 in 1)
Feature	Strong adhesive, non-toxic, environmental-friendly, anti-infiltration, anti-water, anti-aging
Application	Mainly used for pasting all kinds of paper tiles, mosaic and lath bricks indoor and outdoor wall
Surface Preparation	Dry, clean and free of oil stain and other loose substance
Appearance	White power
Construction Temperature	5℃~40℃
Storage	12 months
Surface Dry Time	About 2h
Adjust Time (min)	≥5
Open Time (min)	≥10
Shrinkage %	≦0.50%

 
PB-FTJ Waterproof Grouting Adhesive (3 in 1) is a new type strong adhesive, applied to indoor and outdoor wall paste of large-scale ceramic tile, grassing stone, natural stone material, modifies epoxy glue with features of strong adhesive strength, low stress, low dilatability, no bubble, quick set, proper viscosity and easy operate, resistant of grind, aging, cold-hot exchange.

 
 
Features:
 
1,This product is a new type strong adhesive.
2, The adhesive has certain thixotropy, can finish the adhesion and gap filling at the same time, convenient and save time.
3, Good water resistance function and anti-aging.
4, Environmental friendly, non-toxic.
5, Good anti-infiltration function.
 
 
Application Scope:
 
Mainly used for paste all kinds of paper tiles, mosaic and brick.
 
 
Surface Preparation:
 
1. The substrate shall be dry, clean and free of oil stain and other loose substance.
2. The substrate shall have certain surface strength, common evenness and verticality.

 
Operation Process:
 
1, Mix the tile adhesive with the water by 3.3:1, to be dump-free, standing for 3~5minutes, restir if necessary and ready to use.
2, Use a notched trowel to apply the adhesive onto the working surface, with approximately 1m2 each time, then press the tile stone on the substrate, and adjust the evenness of the tiles; pasting from the bottom to the upper is appreciated.
 
 

Coverage area(amount)	Technical reference
use 6×6mm notched towel, approx. 2.8~3kg/㎡.	Adjust Time (min)	≥5
Open Time (min)	≥10
use 10×10mm notched towel, approx. 4~5kg/㎡	Surface drying time	About 2h
Appearance	White powder
the above-mentioned dosages are recommended for the even substrate.	Shrinkage %	≦0.50%
Normal Shear Strength	≥ 1.0MPa
Water Resistance Shear Strength	≥0.7MPa
Resistance Shear Strength	≥0.7MPa
Freezing and thawing	≥0.7MP

 
 
Cautions:
 
1, Before application, please check the situation of the substrate.
2, Better be used at 5℃~40℃.
3, In summer, when the temperature of the substrate is too high (≥40℃), wet the substrate with water so as to prevent too earlier shortage of water from affecting the quality of application.
4, Do not add water in the cured adhesive and reuse it.
5, Clean the surface of the stone materials with a piece of wet cloth 1~2 hours after the application