Delivery Time:10 working days
Certification:IS09001：2000
Grey Super Mosaic Tile Adhesive Stone Gum For Ceiling Indoor

Product Name	PB-03 Tough Stone Adhesive
Appearance	White, gray power
Feature	Strong bond ability,material-saving,no-toxic,environmental,good flexibility,good anti-infiltration and anti-aging function
Adjust Time	about 15min
Surface Preparation	Firm, dry and clean, no grease, no wax, and other loose materials
Application	Applied to all kinds of low water-absorption stone materials like large-sized artificial stones, culture stones, and natural stones on wall, ground and floor
Dry Time	about 24h(according to the weather)
Cool Time	about 10min
Construction Temperature	5℃~40℃

Product Description

PB-03 Super Stone Gum is a kind of high quality environment-friendly waterborne powder which can be mixed with water and used for bonding ceramic tile on the surfaces of wall, ground and floor. It is easily applied and can achieve an excellent adhesion.
 

Where to use:

For wall surface: To bond ceramic tile (maximum is 60×60cm) on the concrete or cement sand rendering.
 

For floor and ground:

To bond ceramic tile or building stone.
For all kinds of damp place; Swimming pool/tanks, water proof roof and balcony, bathrooms etc.
 

Advantages:

1. Super bonding power, avoid the hollow caused by ceramic tile which contacted with cement;

2. Stable performance, use directly after mix it with water;

3. Strong water retention capacity, no need to soak the tile or wet the wall. Reduce the dosage of adhesive and the load on the building;

4. Good flexibility, resistant to all kinds of impact;

5. Nontoxic, non-radiant, no irritative odor;

6. Special anti-sagging formula, easier application.
 

Technical Data:

Bonding Strength(Mpa)	Standard: ≥ 0.5	After freeze-thaw cycle: ≥ 0.5
After dipped into water: ≥ 0.5
After heat aging: ≥ 0.5
After airing (20 minutes): ≥ 0.5
Color	Grey
Packing Size	20kg/bag(powder)
Shelf Life	Powder (airtight): 1 year

Application Instructions:

1. Surface Preparation:

The surface should be vertical, flat, smooth and free of dust, grease and other Contaminants.
The new cement mortar surface should be maintained at least 14 days before The application of the adhesive.

2. Application Method:

Mix the powder with water at the ratio of 20: (5~6.5), and then use electrical Blender to stir evenly.

Keep the mixture for 5 to 10 minutes, and then stir it again to achieve the best Result.

Finally apply the adhesive on the surface with the notched scraper, and then Put the ceramic tile on the surface and press.

Mixing Ratio (powder: Water): 20: (5~6.5)

Application Tool: Electrical blender, notched scraper(3×3mm, 4×4mm, 6×6mm, 8×8mm, 10×10mm), horizontal ruler etc.

Good Reminds:

1. Application temperature: 5℃~40 ℃.

2. Control the mixing ratio of powder and water strictly to avoid too thick or too Thin and damage its performance.

3. Don\'t add water into the dry and hard adhesive mixture and use it again.

4. If the surface and tile\'s backside is not even enough, apply some adhesive On the tile\'s backside to avoid hollowing.

5. Store in a cool, dry and well-ventilated place.

Store Method: