G5Go No Go Gauge for lamp G5
To check dimensions E max., F min., F max., and the combined pin diameter and displacement of pins (including bosses) of bi-pin caps G5 on finished lamps.
Testing:
The pins of the caps on finished lamps shall enter the gauge at surface O and fully inserted, the surfaces of cap and gauge shall contact.
In this position the end of the pins shall be co-planar with or project beyond surface X, but shall not project beyond surface Y.
Each individual pin shall enter hole e1 at surface O until the face of the cap and the surface of the gauge contact.
Category of G5 Gauges:
7006-46-3: "Go" & "Not Go" Gauge for unmounted BI-PIN cap G5
7006-46A-3: "Go" Gauge for BI-PIN cap on finished lamp G5
7006-47A-2: Plug Gauge for lampholders for testing protection against accidental contact G5