Resistant HighPressure Hose Introduction

Mainly used formine hydraulic support, oilfield development, suitable for engineeringconstruction, lifting, transportation, metallurgy forging press, miningequipment, vessels, injection molding machinery, agricultural machinery, allkinds of machine tools and various industrial departments mechanization,automation has certain pressure in hydraulic system (high pressure) andtemperature of oil (such as mineral oils, soluble oil, hydraulic oil, fuel oil,lubricating oil) and water-based liquids (such as emulsion, oil-water emulsion,water) and hydraulic transmission, the highest working pressure resistant up to70-120 mpa.

High pressurerubber hose is mainly by the hose consists of inner layer protectionlayer, middleor four or six layers wire spiral layer and external rubber cover.

High pressurehose mainly in temperature: - work under 40 ℃ to + 100 ℃, so you must grasp the temperature,do not use undeserved, to bring you unnecessary consequences.

Resistant HighPressure Hose Cleaning Method & Steps

1、According to the locationof the application of drill stand erect position.

2、Cleaning machine iscomposed of motor, reducer, electric control box, temperature control system,guide rail, etc.

3、 Electricity no-load runningfive minutes before drilling, when drilling rig is normal, and the spindlerotation direction with the direction arrow on reducer, power off, drill pipe,low frequency heater. Transmission reducer drive drill rig.

4、Electrical control powersupply system, drilling machine and heating system by control box.

5、Power supply device,through the pipe into the hole bottom, heated oil pipeline. After dissolvingoil outflow.

6．Choose the piston willmelt the crude oil.

7．When the drill to therequired depth, stop going forward, the host exits if necessary, using externalheating system pipe outside the cleanup.