Crown XTI6002 Power Amplifier Specifications
Inputs/Outputs
- Input Connectors: XLR, one per channel
- Link/Out Connector: Loop-thru signal from input connector for linking another amplifier, one per channel
-
Output Connectors:
- 2 Neutrik Speakon; Channel-1 Speakon is wired with Ch. 1 and Ch. 2 outputs for use with optional single 4-conductor cable.
- 2 binding post outputs
- HiQnet USB Connector: Type B, connects to HiQnet network
Performance
- Sensitivity (for full rated power at 4 ohms): 1.4 Vrms
- Frequency Response (at 1 watt, 20 Hz - 20 kHz): +0 dB, –1 dB
- Signal-to-Noise Ratio (below rated 1kHz power at 8 ohms): 103 dB (A weighted)
- Total Harmonic Distortion (THD): < 0.5 percent
- Damping Factor 20 Hz to 1 kHz: > 500
- Crosstalk (below rated power): 20 kHz - 1 kHz: > 70 db
- Input Impedance (nominal): 20k ohms balanced, 10k ohms unbalanced
- Maximum Input Signal: +22 dBu typical
Controls
- Level: Two front-panel rotary level controls, one for each channel
- Power Switch: On/Off switch applies AC power to the amplifier
- Sel/Prev/Next Buttons: Three buttons near the LCD screen that are used to access menu items and front panel lockout
- LCD Screen: Backlit liquid crystal display that shows preset and processing status
Indicators
- Signal Indicator: Green LED, one per channel, illuminates when a very low-level signal is present at input (may be used for troubleshooting cable runs)
- –10 Indicator: Green LED flashes when output signal exceeds -10 dB below clip
- –20 Indicator: Green LED flashes when output signal level exceeds -20 dB below clip
- Ready Indicator: Green LED, one per channel, illuminates when the amplifier is ready to produce audio
- Clip Indicator: Red LED, one per channel, turns on at the threshold of audible distortion
- Temp Indicator: Red LED, one per channel, illuminates under excessive temperature conditions
- Power Indicator: Blue LED illuminates when the amplifier has been turned on and has power
Construction
- Chassis: Steel
- Front Panel: Cast-aluminum
- Cooling: Proportional speed fan with front-to-rear airflow
- Dimensions(WxHxD): 19 x 3.5 x 16.2 inches
- Weight: 24 lbs (10.9kg)