Sell Snow Scraper With CE & RoHS Approval

Model No.:
Product Origin:
Brand Name:
Price Terms:
Payment Terms:
Certification:
Description:Characteristic This product uses the surface shape of silicone rubber heating element, melts the snow efficiency to be high, does not damage the glass and the car surface, to use the low temperature environment,40 degrees centigrade of uses of may to the below zero. It is suitable to snowing the climate, outside the automobile glass is covered by the snow the lid, reduces waited for melts the snow time and enhances the snowy area traffic safety. Scrape snow sawtooth design, can fast eliminates the snow, heater to send out the high temperature to be possible effectively to melt the residual snow or thin ice, upper formation of the soft silicone rubber film eliminate the vestige of water; the ball prominent design, effectively gets hold of the handle, time-saving and effort-saving, for snowy area in best helper. Operation instructions Takes out the scrape snow heater, and the cigar power source plug insert in cigar-lighter of car. This silicone rubber heater to start to give off heat, but first use to scrape snow sawtooth to eliminate the snow on the glass, only remain a little snow or thin ice, then use the base of silicone rubber heater, fast back and forth repeatedly to rub the glass of the car. Waiting the thin snow or thin ice melts to become the water, again uses the upper of the soft silicone rubber film to eliminate the vestige of water, the glass can clear be bright. The use finishes, take out the plug, and the reverse of scrape snow heater for silicone rubber heater, waits the heater panel to cooling (approximately 3 minutes), after to collects. 1. Pay attention matter 2. This product uses dc12v~dc24v (the automobile DC power source), if does not use causes please to draw out the plug. 3. Heating panel manufacture for the soft silicone rubber, do not to use the sharp weapon to cut the destruction. 4. This product heats up the constant temperature is 130 degrees centigrade (constant temperature to output ), heats up the time is about 3-5 minutes, if you use the product needs fast back and forth to moves. If it pause too long on a place of glass is bad, because the temperature difference on inside and outside of glass, it will cause the glass or the automobile surface produces cracks or the destruction, the user must specially pay attention. Material 1. The heater film of outer layer for the silicone rubber, the inner layer is heater. 2. The main body makes for the heat-resisting plastic, the upper rubber panel to eliminate the vestige of water is made for the soft silicone rubber. 3. Consumed power: Dc12v~ 24v/20w~40w. 4. Heater surface size:15x2.5cm; upper rubber panel 16.8cm, thickness:3mm