SM-XLH-8 Semi-automatic block board composer Veneer composer

Usage:

8’ Semi-automatic block board composer is designed for the mass production woodworking factory located at cheap labor cost area.

Characteristics:

1.      The first procedure of operation is to load the glued and arranged strips, just one piece of board’s quantity at a time, into feeding magazine. These strips will be pressed down gently by pneumatic bar, and then pushed into horizontal heating zone by hydraulic push bar.

2.       A solid steel plates is provided on the base of machine to insure stable condition under operation and easy installation.

3.       Pushing (feeding) speed is adjustable. The maximum is 45 strokes per minute.

4.       The locators, 6’,7’ and 8’, erected in feeding magazine, can position the length of product. Meanwhile, a circular saw will cut the over length strips. The rest strips can be used again.

5.       Both upper and lower stem heaters are made of thickened, heat-treated, and planed steel plates, which will not be distorted after a long time of usage. The face of steam heater is extra wide to insure producing smoothly and stably.

6.       There are four individual hydraulic pillars, which can lift the upper steam heaters. Therefore, the gap between upper and lower steam heaters can be adjusted separately, according to the thickness of product.

Technical details:

Length of product: 1880~2514mm(6”.7’,8’)

Strip thickness: 8~25mm

Strip width: 35~50mm

Motor of oil pump: 10HP×4P, 1 set

Motor for circular saw: 5HP×2P, 1 set

Power: 10.5KW

Steam pressure: 3~7 kgs/cm²

Compressed air: 5.0 kgs/cm²

Max. pushing speed: 45 strokes/min.

Hydraulic control system: 1 set

Pneumatic control system: 1 set

Electric control system: 1set

Upper steam heaters: 130×130×4000mm×17pcs

Lower steam heaters: 130×130×3715mm×17pcs

Consumption: 70kgs/h

Dimensions: 5420(L)×3260(W)×2050(H)mm

Net weight: 7000kgs

Gross weight: 7500kgs

Block Board Composer pictures