Specifications

Quick Lock Cable Terminals
Material: Stainless 316
Avaliable for cable diameter aa3, 4, 5, 6, 8mm

 

 

 

 

 

Quick Lock Cable Terminals

 Features:  

* To have your construction fixed against storm

* As a Cable Railing for Indoor or Outdoor
* Material: Stainless 316
* Avaliable for cable diameter Φ3, 4, 5, 6, 8mm
* Capacity: 3mm 500kg, 4mm 1Ton, 5mm 1.6Ton, 6mm 2.5Ton, 8mm 3.5Ton

 

  Assemble instructions  

1. First side the jaw housing in place on the cable.

2. Next, side the jaws onto the cable leaving some space between the jaw sections.
3. Place the brass pressure ring on the end of the cable. Make sure that the distance from

    the pressure ring to the end of the cable is 5 mm.
4. Side the jaw housing over the jaws.
5. The terminal can now be assembled. Screw the head firmly to the jaw housing with a spanner.
    then tighten the lock nut firmly with a spanner.
6. When assembling the terminal a non-acidic sealing compound must be use in the housing, sikaflex 221, for example.
    Disassemble the terminal and fill the jaw housing and the cavity with sealing compound, then assemble
    the terminal. Repeat this until the sealing compound emerges from the hole through which the cable is
    inserted. Clean the terminal. Do Not reuse the jaws. Make sure that the dimensions of the terminal
    and cable match.

 

  Maintenance   

Check the terminal regulary for damage in connection with longer exposure to concentrated saline
solutions or polluted surroundings. Cjeck tha seal, if it broken remove all sealing compound.
Then rinse the terminal with fresh water and treat it with WD40. Reseal the terminal with non-acidic
sealing compound.

 

  Note    

After the first dynamic load the terminal MUST be tightened again. The terminal was developed for use with
following types of cable: 1x19, 7x19 and 7x7. The terminal can also be used with Dyform (Compacted strand)
When assembling terminals the breaking strength of the cable used will be reduced by 0-15%.