TC-G158 Robot lawn mower, buy Robotic lawn mower TC-G158 on China Suppliers Mobile

Product Details

Robotic lawn mower TC-G158

--Colors:

1. Lift sensor
There is a lift sensor located on each front wheel. If the mower was lifted 2cm from the ground in a level way, the blade stop working within 2s, but the wheel keep running. And the blades start cutting within 5s after two front wheels get back to ground.

2. Tilt sensor

There is tilt sensor installed on the mower too, when the mower was titled over 30 degree at any direction, it also will stop working within 2seconds

3. Bump sensor
In front of the mower there equipped with bump sensors that will activate when the mower strikes solidfixed object when that object is at least 6.5cm in vertical height from the supporting surface of the mower. When the bump sensor is activated, the mower will stop movement in that direction and reverse itself away from the obstacle.

4. Rain sensor
There are two rain sensors on the top cover of mower.
The mower will go back to the charging station automatically when it’s raining.

5. Wireless controller
Remote-operated the mower

6. Anti-theft function
The mower should be turned on by key. And it can’t start working without a matched charging station.

7. Virtual wire
The robot lawn mower can’t operate without the virtual wire. (We suggest you to use 100m-300m of virtual wire).
It leads the mower back to charging station and the mower will take is as a wall when it is working.
It will get on the virtual wire until it meets charging sheet which located in front if charging station,
then it gets off virtual and start cutting.

8. Auto recharge system
If the mower is powerless while it in operating, the cutting motor turn off at once and it will find the virtual wire then go alone it back to charging station for recharge automatically. (This allows you to keep the charger connected with the charging station all the time, even after the battery is fully charged.)
On auto pattern, the mower will go on mowing after fully recharged.But if it is on manual pattern, it will just get back from charging station for a few centimeter after fully recharged.

9. Emergency stop switch
There is an emergency stop switch located on the back of mower and red in color.
If you press it in any case during operation, the mower must stop all movement and stop the rotating of blades immediately. Rotating the switch resets it.

10. Two cutting modes
There are two cutting modes of the mower, go straight and go circle (high efficiency).

--Packing:

1.Virtual wire(100m)

2.Pegs(100pcs)

3.Blades(2pcs)

4.Stakes(4pcs)

5.Charger (1pc)

6.Charging station

7.Remote control

8.Remote control battery(2pcs)

9.Wire connector(10pcs)

10.Keys(2pcs)

11.Inner hexagon spanner(1pc)