Product Details

CE FY91H 1/8-2'' inches 10set free dies hydraulic hose crimping machine price

Brief Introduction of hose crimping machine

The hydraulic hose crimping machine is mainly used for buckling processing for hydraulic rubber hose assembly in the mechanical engineering. It can also be used for buckling the two-way bends, especially large bends and irregular shape bends. This machine features small and portable appearance, big force, low noise and easy to operate. The buckling amount can be precise adjusted through a scale.It makes the mould base division to be more even through the double inclined plane eight-flap mould seat equipped with a high accuracy guiding device.

Technical Parameters of hose crimping machine

FY91H 1/4" to 2" 4 wires hose crimping machine(metal hose,air hose,wire rope etc.)

Only it is in this scope,FY69 can do crimping work.

1 Hose capacity:4-51(mm) 1/8" to 2"4 wires4SH 4SP with 10 free mould dies or more as request

2 Swaging Force: 530(T)

3 Press Number:14.5L/min

4 Max Pressure:30(MPa)

5 Opening without dies:119mm

6 Die Opening and Closing:+/-20(mm)

7 Calibration:Simple dial adjusted Calibrator

8 Weight:210(Kg) with packing

9 Noise Level:68DB

10.Packed Dimensions(Length*Width*Height):720x520x820(mm)

Pictures show

The picturers of hose crimping machine

How to Correct a Crimping Hydraulic Hose

Crimping refers to the method used to attach fittings to the end of a hydraulic hose.

Special crimping machines can be used to ensure the ends are properly fitted to the hose.

Crimping machines can be rented or leased from crimping manufacturers.

These machines generally follow the same procedures during the crimping process.

Instructions

Mount the crimping machine on a workbench. Depending on the weight of the crimping machine, the workbench used must be able to support at least 136 Kilogram or more.

Remove the plug from the hydraulic reservoir located on the crimping machine.

Insert the vent cap into the reservoir. The vent cap is supplied with the unit.

Plug the crimping machine into a dedicated electrical circuit. Avoid using extension plugs. Instead, plug it directly into the wall.

Select the die cage based on the size and style of the hose. The crimping machine instruction manual will contain complete, detailed crimp specifications.

Load the die cage by extending the ring's length as far as it will go.

Use the adjustment knob at the top of the machine to determine the diameter of the crimp for each hose, fitting and die cage. The settings range between 000 and 400. Adjust the knob between these settings to the number found on the crimp setting chart. Each downward rotation increases the setting by 025. Rotate the knob downward until you reach the desired setting.

Press and hold the crimp switch in the upward position to insert the fitting. Toggle the switch up and down to reposition the fitting if necessary.

Wait for the machine to finish crimping the fitting. The machine will stop and the black guard will move up and over the red indicator ring on the adjustment knob.

Remove the crimp hose assembly by pressing and holding the crimp switch in the downward position. The machine will release hydraulic pressure.

Inspect the diameter of the crimp in the fitting and verify that it is correct.

using our hydraulic hose crimping machine to Crimp hydraulic hose:

Packing of Electric hydraulic hose crimping machine:

PTC FAIR OF OUR BNT91B HYDRAULIC HOSE CRIMPING MACHINE:

Call me freely or send email or add the online tools to chat,if any demands.