T type Ingot Mold

1).Both Standard & Customer Design are available here. You can even have your company's Logo casted on our products.The mold sizes listed in the following table will satisfy most requirements. The low profile design was developed to reduce the shrinkage cavity in the aluminium casting, and is now widely used by most major producers.

2).V-Process Casting. We are able to produce these products below 2.5 Metric Tons via V-Process Method.An vacuum process automatic moulding and production line has been buit up here and much more larger castings can be casted then. Compared with sand casting,V-Process castings have lots of advantages:

a.  Low Operationg & Tooling Cost.

b.  Tight Tolerances.

c.  Fine Finish Surfaces(Fine surface is very important for removing sows or ingots from the moulds).

d.  Quick Turnarounds and Short Lead Times.

e.  Thin-Wall Capability.

f.  Unlimited Pattern Life.

3).Castings between 20kgs to 10 000 kgs are available here.

4).Material: Carbon Steel,Alloy Steel,Stainless Steel, Ductile Iron of All Standards or Customer Specifications.

Maybe you are interested in: