Specifications

Truck Wheel Fender
Made by Hand Layer Up FRP
Lower tooling cost for low volumes
Experience.Quality.Service

Truck Wheel Fender

 

Truck Wheel Fender made by Hand Layer-up FRP/Fiberglass

 

 

Advantages of Hand Lay-Up Fiberglass/FRP(Fiber-Reinforced Plastics)

• Lower tooling cost for low volumes
• Wide range of part size
• Design features easily implemented and changed
• Flexible part qualities, from strong and thick to thinner and lightweight
• Can incorporate minor assemblies
• Typically faster than RTM
• Accurate, though resin shrinkage should be factored into design

Hand Layer-up Fiberglass/FRP Process

 

 

 

 

Description of Hand Layer-up Fiberglass/FRP(Fiberglass Reinforced Plastic)

 

 

• The parts made via Hand Layer-up FRP(Fiberglass Reinforced Plastic) are created by applying liquid resin and fiberglass mat along with gel-coat onto an open-faced mould. The fiberglass mat will be laid into the moulds and the resin will be brushed into the fiberglass mat carefully according to the temperature and humidity situations. The semi-product after demoulded will be trimmed according to the drawings. Then the parts will be cleaned and polished to be packed.
• Hand Layer-up parts are lighter and perform better on high strength-to-weight ratios. The parts made from hand layer-up FRP are with one side smooth—the gloss can be above 80. Now these parts are widely used on boat hulls, auto parts, truck and tractor covers, chemical retainers, heavy equipment panels, even rubbish cabins etc.