Style: clamp saddle

Media: Water

Connection: Gluing, Solvent Joint (Rubber Ring)

Pressure:  PN10/PN16

Standard:     GB10002.2-1998; ISO4422.2-1996

Certification:  ISO9001:2000; ISO14001:2004

Advantage:   Light weight, High strength, High flow capability, Easy

installation, Endurable, Economic, Nontoxic, Corrosion

resistance, Recyclable, Environment-friendly

Physical properties: Density, 1350-1460; Vicat softening temperature≥74;

Hydroscopicity≤40; Oven test, no signs of bubbles or cracks 

Mechanical properties Drop test, no cracks with all samples; Hydraulic test, no leak

Properties of Products

1. Light weight

 The weight per unit is only 1/6 of the cast-iron pipes,so the transport is quite convennient.

2. High strength

 The strength can get to 45Mpa.

3. Low resistance

 The internal surface of the pipe is smooth with no dirt and no blickage.The loss is 30% lower

 than that of the cast-iron pipes.

4. Corrosion reistance

 It has a good quality of acid resistance,alkali resistance,chemicals resistance and electro-  

 Chemistry resistance,so the point of corrosion will not occur during the use.

5. Easy instal lation

 It adopts the glue and soft joining.Therefore,the installation is quite easy and the sealing is

 Reliable

6. Long service life

 The service time can reach more than 50 years nuder the normal working pressure.

7. Low cost

The cost of the transport and instal lation is low,and the total engineering cost is 30-40% lower

 than of the cast-iron pipes.

8. Innocuity and sanitation

  The product conforms to the standards of the drink water and water transported has no second pollu-

 tion.

Connecting the soft joining pipes and fittings:

At first, clean the inside wall of the extended interface pipes and the outside one of the plug-in part of the vertical pipes. Then measure the length of the extended interface and make a mark on the plug-in vertical pipes.(The marked length should be shorter than the actually measured one ) Thirdly, turn the rubber ring into the fillister of the extended interface.(Make the side of the rubber ring with a bevel outward and manicure the plug-in pipes into a bevel with a steel file or a grinding wheel. The products of our factory have the bevel surface automatically.) Lubricate the rubber ring and the plug-in part of the vertical pipes.Finally, insert the plug-in part of the vertical pipes into the extended interface and place it in the marked position with a line machine.(Either use a line machine or a lever during the process of installation in terms of the practical situation.