Product Details

Specifications

12/24V rocker switches with two colors LED lights!
Anti-corrosion ABS plastic panel
2 colors of LED lights
Red&Blue Lights

ON-OFF laser etched rocker switch

1.Abs plastic panel

2.waterproof rocker switch
3.500000 Mechanical Life
4. Process can be screen printing and laser carving

5. It has a face surface size of 0.90'' x 1.92'' and uses a standard din size mounting hole. Cutout Dimensions are 0.83'' x 1.45''.

These high quality 12 volt Rocker switch is a single throw ON - OFF switch designed to operate your 12 volt accessories. They have a face surface size of 2'' (50mm) x 1'' (25mm) and uses a standard din size mounting hole of 1.41'' (36mm) x .86'' (22mm) this is the standard size of most switch holes in modern vehicles, however it is best to check your particular hole size if unsure.

Single Pole Single Throw ON-OFF switch.
12VDC 20Amps, 24VDC 10Amps 125VAC 16Amps, 250V DA10Amps.
Black hard surface rocker.
Two LEDs in the switch.
Upper LED is ON only when the switch is turned ON.
Lower LED is independent.
Both LEDs have separate grounds.
Same size as the Carling and ARB switches.
Rated 16A 12V.
No rear barriers between terminals.
Photos on the samples for your reference:

- ingle Pole Single Throw ON - OFF,ON-OFF-ON switch
- Black hard surface rocker.
- Laser etched ROOF LIGHTSLegend
- Single upper L.E.D light.
- Single lower L.E.D light.
- Upper light is ON when the switch is pressed UP.
- Lower light can be wired to separate dash light circuit.
- Same size as the ARB switches.
- Rated 20A 12V.
- This switch uses the same light configuration as the ARB switches.
- No rear barriers between terminals.
- Wiring diagram supplied with switch.
- Switch cut out size 0.83'' x 1.45''.
- Panel thickness between 1/16'' and 1/4''
All symbols are Laser etched directly onto the switch face using modern high Tech laser engraving equipment to ensure long image life.
The switch is rated at 20amp's however in ALL case we recommend that you wire the accessory through a fused relay.