FEATURES

• Bronze Construction - Corrosion Resistance
• Large Suction and Discharge Ports
• Polytetrafluoroethylene (PTFE) Barrier Seals Protecting Ball Bearings
• Mechanical Carbon Ring, Ceramic Face Main
• Pump Seal Standard, Optional Nitrile Lip Seal
• Two Sealed Ball Bearings Spaced for Maximum Load Ability
• Large Vent & Drain Openings Separate Seal & Bearing Areas
• Shaft Slinger for Additional Bearing Protection
• Neoprene Impeller Standard, Nitrile Impeller Optional
• Passivated 316 Stainless Steel Shaft
• Extra Capacity Ball Bearings plus Rugged Construction for Prolonged Service Life
• Impeller & Cam Easily Replaced

DRIVE

Direct drive with flexible coupling or pulley drive can be used. Make sure both flexible coupling halves are properly aligned. When using pulley, do not over-tighten belt.

LIQUIDS & TEMPERATURES

Liquids compatible with neoprene can be pumped including fresh and salt water solutions and mild chemicals. Do not pump severe solvents or acids. When possible, flush pump with fresh water after each usage. Nitrile impellers can handle oil contaminated water and kerosene at reduced impeller service life. Extremes of cold and heat will affect impeller life. Limits of 40^o to 180 ^o F should be observed. Do not allow liquid in pump to freeze. Drain pump by loosening cover screws. Use methyl alcohol based anti-freeze compounds such as Zerex, Shell Zone, Pyro Permanent, Permagard, and Dowgard.

SUCTION LIFT

Suction lift of 15 ft. is possible when impeller is wet. Suction lines must be air tight in order for pump to self prime. A foot valve at the beginning of suction line is recommended.