Steel Nail Making Machine Production Line(whatsapp:+8615937198193)

available raw material: 

1.new steel wire coil (both high carbon and low carbon type are all okay)

2.waste steel rebar get from construction(must belong to low carbon series), and diameter comes within 12mm .

3.tyre bead wire (need annealing treatment in advanced)

Workable final nail shape by using our steel nail making machine production line:

Our production line originally is designed for processing common wire nail , but if adding other special auxiliary equipment like corrugated nail machine , umbrella head making machine , galvanized machine , thread rolling machine and etc , will can be further to make screw nail ,cement nail , and roofing nail .

 Spare parts: 

punch pin ,nail knife,nail mould,and steel ball(for this one you can buy from your local market )

Specifications  :

Flowchart of Steel Nail Making Machine Production Line

1.wire drawing machine

draw out the big rebar(wire) into smaller diameter which keep same as the final nail you plan to make ,meanwhile the rust which attached on the surface also will be removed if you take our scrap steel bar style wire drawing machine or horizontal style drawing machine .

2.steel nail making machine

pre-set the length of nail you desired , then put the wire line into its hopper .

3.steel nail polishing machine

help to remove the rust which sticked on steel nail (to guarantee them seems more bright) ,notes that add some sawdust ,paraffin and oil inside when polishing .

 Remark: Except what aboved machine , other three kinds auxiliary equipments respectively for nail knife sharpener , pointing rolling machine , and butt welding machine are also needed for processing common steel wire nail . 

Business Card

Features of our steel nail making machine production line :

1.20M2 workshop are okay ,and just need 3 people to operate for the whole production line

2. Both of the scrap iron wire and the new steel rod can be used to make nails.The profit using wasts steel is 5 times of that using finished steel

4 The most important part of principal axis are made in S45C steel and moreover treatment via heating , so very durable .

(designed in a whole body but not assemble type)

5. This machine adopts closed plunger type transmission structure so as to ensure the features such as high speed, low noise and less impact(self-lubricating).

 6. can feed the materials automatically. Once start, it could make nails continuously.

7 A friction gear is installed between crankshaft and flywheel. It plays a protective role of safety when the machine breaks down or overloaded.

8.use control handle at the inlet place in order to control incoming line at any time during operating.