Wire Nail Production Line,Nail Maker, Nail Making Machine

Function of Wire Nail Production Line:

To make the steel bar into high quality of iron nail ,rivet,body of roofing nail(asphalt felt nails, linoleum nails), cement nail and other special shaped nails used for high speed coil nail welder and coil nailer if we changed the stamping structure,nail mould and nail knife.

Spare parts of Wire Nail machine: 

punch pin ,nail knife,nail mould,and steel ball(for this one you can buy from your local market )

upper one is nail knife , and the lower one are nail knife

Specifications from line in wire nail production machine:

Flowchart of working procedure

1.wire drawing machine

draw out the big rebar into certain diameter which keep same as the nail you plan to make ,meanwhile the rust which attached on the surface also will be removed if you take our scrap steel bar style wire drawing machine or horizontal style drawing machine .

2.ail making machine

pre-set the length of nail you prefer , then use this machine to produce the wire nail .

3.polishing machine

to make the finished nail more bright ,notes that add some saw powder,paraffin,oil and other material in the machine when polishing .

 tering and packing the nail with wooden box for marketing (You can also pull into the grid mesh cages, sheds, hangers, car baskets.)

auxiliary equipment:

1.butt welding machine(used to connect the end of two wire rod together for further continuous production ),it is only used for the continuous drawing production line .

2.a pointing rolling machine is necessary no matter what type wire drawing machine you used if your raw material is new bar.Itwill be helpful for you to put the raw material into the feeder of nail maker .

3.our continuous type wire drawing machine do not have the rust removal function as working ,so if your material are new wire rod ,you have to buy another special derusting machine from us to ensure the quality of nail

4.discharge wire machine (replace the labour to unload the heavy wire after drawing ),this is machine just is used for the continuous drawing production line .

Here as aboved two photos are helpful to show the difference of working procedure when use different raw material .

Photos of the finishd nail

Business Card

Features:

1.20M2 workshop are okay ,and just need 3 people to operate for the whole production line

2. Both of the scrap iron wire and the new steel rod can be used to make nails.The profit using wasts steel is 5 times of that using finished steel

4 All the main components are made of quality steel, such as shaft, cams and gear.

5. This machine adopts closed plunger type transmission

 structure so as to ensure the features such as high speed, low noise and less impact(self-lubricating).

6. can feed the materials automatically. Once start, it could make nails continuously.

7 A friction gear is installed between crankshaft and flywheel. It plays a protective role of safety when the machine breaks down or overloaded.

8.use control handle at the inlet place in order to control incoming line at any time during operating.