Product Details

auto plaster render machine

Product Description

ZB800-4A Technical data
Plastering Height	0-5meters
Plastering Thickness	2-25mm
Plastering Width	80cm
Capacity	450 square meters/8 hours
Dimensions	800×650×480mm
Voltage/frequency	According to your demands
Weight	150KG
Surface	smooth
Vibrator	2 vibrators
Juncture device	Yes
Smoothing knife	Yes
Perpendicularity degree	≤2mm
Level degree	≤2mm

Detailed Images

operation

Step 1.fix the machine

Step 2. load ash

Step 3. go up to the first plastering

Step 4. go down for the first smoothing

Step 5. the first section of plastering wall is finished

Step 6.repeat step1-5

Packaging

FAQ

Machine doesn't go down Hydraulic is very fastness, any bulge will stop the machine
1. Shake the upright tube strongly.
2. Use Supporting square tube to pry down it.
3. Loosen the hydraumatic, and then lock it again.
If intermittent stop on the way
1. Nylon wheel is lack of oil, take out the pin roll and put some oil on it
2. There are sand on the upright tube, please wash it by watered woven bag
3. There are sand on the nylon wheel, pull out the upright tube, knock out the drivepipe by hydraumatic, wash the drivepipe by high pressure water.
The machine go down without smoothing Two of the gas spring need do forward adjustment
The machine go up slowly or cannot go up The motor v-belt is loose, please adjust it tighten
Difficult moving Pry up the machines’ chassis, then prick a hole on the mineral water bottle to wash the universal wheel