Specifications

Two-stage Crusher
1)Raw materials:coal slack,cinder,shale,etc;
2)Features:high capacity,low consumption,easy operation,etc.

Descriptions:
1.Two-stage Crusher is applied to crush  highly wet and hard materials such as coal slack,cinder,shale, construction waste,slag,furnace slag,refractories,cement,heat insulating materials as well as other  kinds of building materials.

2.Better crushing effect can be accomplished in respect of building of  brick plant and coal separation plant.

 

Features:
1)big crushing rate;   
2)wet materials can be broken;                     
3)two-stage and non-sieve at the bottom;
4)Robust construction and easy operation;            
5)save electric 20%.

 

Advantages:
1. it does not grate at the end of mesh, all kinds of wet materials can be crushed, slag removed from the water can also be crushed at any time, there is no bond to plug the phenomenon.

2.upper and lower levels  smash, broke large materials into small size,the expected size is of not more than 3mm, which can meet the requirements of  standard bricks, hollow brick.

3.it has high output, and the consumption is low.

 

Working Principle:
Two-stage Crusher works,  two motors drive the two sets of rotors rotate with  high speed, materials in the inner cavity are crushed  by higher level rotor and then crushed  immediately by the hammer of  rotating subordinate  rotor  finely, and in the inner chamber materials collide each other, form  the grain-size less than 3 mm cinders particles.

 

Main Technical Parameters:

Model	Feed in size (mm)	Output size (mm)	Capacity (t/h)	Motor power (kw)
2PCX400*600	≤100	≤3	15-25	18.5+22
2PCX600*600	≤120	≤3	25-35	22+30
2PCX600*800	≤150	≤3	45-65	45+55
2PCX800*1000	≤200	≤3	80-100	75+75