Product Details

Product Description

Diesel Generator Set Speed Control Panel ESD5550E

Product Description

ESD5550E Genset Speed Governor

The ESD5550E Series speed control unit is an all electronic device designed to control engine speed with fast and precise response to transient load changes. This closed loop control, when connected to a proportional electric actuator and supplied with a magnetic speed sensor signal, will control a wide variety of engines in an isochronous or droop mode. It is designed for high reliability and built ruggedly to withstand the engine environment.Simplicity of installation and adjustment was foremost in the design. Noninteracting performance controls allow near optimum response to be easily obtained.

The primary features of the ESD5550/5570 Series speed control unit are the engine STARTING FUEL and SPEED RAMPING adjustments. The use of these features will mimimize engine exhaust smoke experienced prior to attaining engine operating speed.

Other features include adjustable droop and idle operation, inputs for accessories used in multi-engine or special applications, protection against reverse battery voltage, transient voltages, accidental short circuit of the actuator and fail safe design in the event of loss of speed sensor signal or battery supply.

PERFORMANCE
Isochronous Operation/Steady State Stability	±0.25% or better
Speed Range/Governor	1K-7.5K ntinuous
Speed Drift with Temperature	±1% Maximum
Idle Adjust CW	60% of set speed
Idle Adjust CCW	Less than 1200 Hz.
Droop Range	1-5% regulation
Droop Adj. Max. (K-L Jumpered)	400 Hz., ±75Hz.per 1.0 A Change
Droop Adj. Min. (K-L Jumpered)	15 Hz., ±6 Hz.per 1.0 A Change
Speed Trim Range	±200 Hz.
Remote Variable Speed Range	500-7.5 Hz.or any part thereof
Terminal Sensitivity	J	100 Hz., ±15 Hz/Volt @ 5.0 K Impedance
	L	735 Hz., ±60 Hz/Volt @ 65 K Impedance
	N	148 Hz., ±10 Hz/Volt @ 1 Meg. Impedance
	P	10V DC Supply @ 20 ma Max.
Speed Switch Adjustment Range	1000-10000 Hz.
ENVIRONMENTAL
Ambient Operating Temperature Range	-40° to +85°C
Relative Humidity	Up to 95%
All Surface Finishes	Fungus Proof and Corrosion Resistant
INPUT POWER
Supply	12 or 24V DC Battery Systems (Transient and Reverse Voltage Protected)
Polarity	Negative Ground (Case Isolated)
Power Consumption	50 ma continuous plus actuator current
Actuator Current Range @ 25°C - (Inductive Load)	Min.		2.5 Amps
	Max.		10 Amps continuous
Speed Sensor Signal	0.5-120 Volts RMS
Speed Switch Relay Contacts(N.O. And N.C.)	10 Amps
RELIABILITY
Vibration	1G @ 20-100Hz.
Testing	100% Functionally Tested
PHYSICAL
Weight	1.8 lbs. (0.82kg)
Mounting	Any Position, Vertical Preferred

ISO9001 Quality System Certification

More Products we produce: