Specifications

1 Outside diameter(mm) 8-20MM
2Thickness(mm) 0.5-1.2MM
3material PE
4even degree(%)>=85
5Water discharge rate(L/H)2-4

  PE plastic drip irrigation pipe of column emitter

 

Brief Introduction:

 

The firstly processed labyrinth round dripper is stuck on the pipe and then the hole is made one the water outlet position of the dripper.

 

Features:

1. The labyrinth flow path is long, ensuring that the water dripper is even.
2. High water pressure and long flow path enable the turbulent flow inside the emitters so that the emitters can wash themselves continuously.
3. The filter square of water dripping entrance is big then the anti-blocking capacity is strengthened.
4. There can be one, two or four water dripping outlets on each emitter, which greatly lowers the risks of water interception due to the outside blocking.
5. The dripper is installed before being taken our from the factory which saves labor cost and reduce the investment.
6. The paving length can reach 300m.
7. It is hard and can be used in the four seasons.
8. Compared with others, the suitability and anti-clogging is strong.
9. The requirement for the water quality is low. Water flow is more steady and longer service life.

Application: It is widely used in desert, city greening, economic crops, greenhouse, garden and full buried type irrigation.

 

Sizes:                          

 

Outside diameter(mm)	Thickness(mm)	Rated working pressure(Mpa)	Water discharge rate(L/H)	Water outlet space(mm)	Filter mesh quantity(mesh)	Max. paving length	Even degree(%)	Each roll length(m)
Φ8 Φ10 Φ12 Φ16 Φ20 Φ25 Φ30	0.5 ~ 1.2	0.1	2 ~ 4	≥200	120	300	≥85	≤500

 

 

machine show 

 

 

 

 

 

 

application

 

 

Factory show

 

 

cooperation