2015 China factory sale Knife grinder used for sharpening the drum chipper knife   008618937187735

1. The general introduction of the   Knife grinder used for sharpening the drum chipper knife 

1,when sharpening,need to press the blade tightly,then start the switch.

2,When switch start,It is forbidden to reverse, Must be started in the direction shown by the arrow,and adjust direction switch timely.

3,When switch start,first  to Start the grinding wheel switch,then start travel switch

4,When sharpening,the machine is advisable to put five times per minute or so, can be continuous use, if more than 5 times, should be pay attention to frequency conversion motor to heat up, in case burn out.

5,Grinding wheel screw can debug by itself.

6,If the machine with automatic lifting plate, debugging board Angle first, and then put the screws, set, adjustable trip to meet again, at run time, the lifting plate tooth run a stroke can touch on the lifting screw gear of a tooth.

7,The travel swith can adjust by itself from 300-800cm.

2. The specification of the  Knife grinder used for sharpening the drum chipper knife 

It can sharpen different types of the knives for different wood chippers :